RX8Club.com

RX8Club.com (https://www.rx8club.com/)
-   Series I Major Horsepower Upgrades (https://www.rx8club.com/series-i-major-horsepower-upgrades-93/)
-   -   Ultimate corner seals for Renesis with rx7 apex seals (https://www.rx8club.com/series-i-major-horsepower-upgrades-93/ultimate-corner-seals-renesis-rx7-apex-seals-274444/)

MilosB 03-28-2023 12:50 AM

what are your opinions on reusing the old plugs ?

I want to provide this all with lowest cost to the end costumer (the machining).
if I have to purchase the corners, that has to be than taxed both when I import, and when the next buyer takes it (especially on "one off" basis, where its very hard to justify tax exemption paperwork), and also I would have much more money "invested" in the whole.

But I have to consider simply purchasing few sets of Mazda and get a good price.

Brettus 03-28-2023 01:28 AM

Not a wearing part so I see no issue reusing old plugs .

TeamRX8 03-29-2023 11:09 PM

failed to read properly; my dumb bad

they oscillate back and forth rotationally with the apex seal (it’s not static at all) in addition to the apex seal sliding in and out from the springs underneath keeping them in contact with the rotor housing face (except when ski jumping off spark-plug mountain) and the corner seals also have springs keeping them in contact with the iron side plates, all while the rotors orbit at 1/3 the engine rpm level.

but as you will …
.

Brettus 03-30-2023 02:15 AM

We are talking about the plugs Team ...not the corner seals.


All times are GMT -5. The time now is 02:13 PM.


© 2024 MH Sub I, LLC dba Internet Brands