JessiahC's Nitrous Build Thread
 

Finally finished my nitrous build, thought I would share the pictures with you guys and answer any questions you might have! Most of the pictures are straight forward. Mounted everything to the stock airbox tray for convenience. I have the full size pictures that I can post on request. I autoresized most of them.

For picture below: Complete look from the front:
https://www.rx8club.com/picture.php?...ictureid=29307

Look from left side under intake.
https://www.rx8club.com/picture.php?...ictureid=29295

Look from right side under intake.
https://www.rx8club.com/picture.php?...ictureid=29296

From rear, driver side.
https://www.rx8club.com/picture.php?...ictureid=29297

The purge system mounted on the grounding bolt with the hard line pointing out the side vent.
https://www.rx8club.com/picture.php?...ictureid=29308

Nozzle mounted into the Black Halo Racing Throttle Body Spacer.
https://www.rx8club.com/picture.php?...ictureid=29298

Aeromotive Fuel Line Tap, which was 6AN so had to reduce to 4AN hence the blue connectors.
https://www.rx8club.com/picture.php?...ictureid=29299

Remote Bottle Opener clears the bar by about 3 inches.
https://www.rx8club.com/picture.php?...ictureid=29305

Picture of bottle, mounts, heater and opener.
https://www.rx8club.com/picture.php?...ictureid=29306

Interior, tray lid closed for stealth mode, lol.
https://www.rx8club.com/picture.php?...ictureid=29304

Tray lid open, doesn't look great right now but the covering vinyl still yet to be cut and applied is on the passenger seat.
https://www.rx8club.com/picture.php?...ictureid=29301

When switches are on, rings turn blue. From left to right bottle heater toggle, control box arm toggle, purge momentary and the Glowshift Pressure Gauge.
Despite the picture, the colors of the switches are exactly the same.
https://www.rx8club.com/picture.php?...ictureid=29303

Thanks for checking it out!

Wondering why none of the pictures are working....

sub'd ... can't wait to see the pics

Pictures Fixed!

Looks awesome
Luv that nitrous gauge pod ash tray mod (WIN)

Thanks a ton. I went though a lot of plastic to get it the way it is now, lol. I've got the blue vinyl to lay over it to make it look extra pro. :naughty:

wow looks clean! Congrats!

Thank you very much!

The lights on the purge are very weak because of how much power the purge pulls, so I'm going to put in a relay to brighten them up. If that doesn't work then I'll replace them.