Injector size conflicting information

06-23-2018, 03:48 AM

#1

Blackwell

Registered

Thread Starter

Join Date: Jan 2018

Location: Kamloops BC

Posts: 60

Likes: 2

Received 10 Likes on 7 Posts

Injector size conflicting information

I've just finished getting my Haltech all wired in. I'm in a situation where I just need to get the car running and moving not yet looking to make mad power or anything. Wish I could afford nice injectors but for the short term I am just using the factory injectors I have available. Thing is I only have 4 injector driver on the haltech so I am just running primaries and secondaries no P2s. The haltech works on volumetric efficiency so I just need accurate values for the injector flow rates and I should be ok. Here's what Ive found thus far

Quote:

Originally Posted by MazdaManiac

I wanted to put all of this in one place for reference.

PRIMARY INJECTORS
RED 290cc

6-PORT SECONDARY INJECTORS & PRIMARY 2 INJECTORS
YELLOW 380cc

4-PORT SECONDARY INJECTORS
BLUE 480cc

Injectors are Bosh disc-type, high impedance (13 ohm) with a Denso connector

But then I see this

Quote:

Originally Posted by Brettus

I believe the scaled output figure used in the ECU is actually a fairer indication of injector output than what you get from a flow test which is done at a lower pressure than our system pressure, so that's what I'm using here.

Injectors listed In this order: P1/secondary/P2

Stock injectors
red/yellow/yellow .................................369/475/475 x2 = 2638cc = up to 270whp
good for a stock greddy turbo kit

Stage 1:
yellow/yellow/blue .................................475/475/626 x2 = 3152cc = up to 330whp
Upgraded greddy turbo

Yellow/blue/blue.......................................475/626/626 x2 = 3454cc = up to 360whp

Stage 2:
yellow/blue/uncapped yellow...................475/626/850 x2 = 3902cc = up to 400whp
Most kit turbos

Yellow/uncapped yellow/uncapped yellow...475/850/850 x2=4350cc = up to 450whp

Stage 3:
Blue/uncapped yellow/uncapped yellow ......626/850/850 x2 = 4652 = up to 480whp
Custom turbo systems

For Uncapped yellow injectors add 10% to all the numbers in the blue injector latency map for best results .

According to the logic in the second thread I should be able to get away with yellow primaries (475cc)and de-capped yellows (850cc) in the secondaries to get stock fueling (2650cc) level which should be fine for my setup anyway I'm only looking to hit 250ish whp anyway.

So now the question is which values are actually accurate for me to enter as my injector size in the Haltech?

Using that MazdaManiac fellows sizing I feel like I would be way short fuel. 380cc+(676cc approx) x 2 = 2112cc

Reply Like