Amp light question
I just got my system installed and i noticed every like 2 min the bass cuts in half...than a few seconds later it fully kicks in...than cuts in half etc.....so i opened my trunk and when the bass cuts in half a red light on my amp comes on,than when the bass fully comes on the regular amp light goes back on. Is it overheating or something? i touched it and it didnt feel hot..barely warm. What can i do to fix this.
|
you have the subs wired wrong...how many ohms is the amp stable too...how many ohms are you running it at?
|
thanks for the quick response.Im not into systems like that so i cant even give u a straight answer. The shop did the install for me. These are the specs on the speakers and amp if it helps.
Subs: CVR12 Outer Frame Diameter, in (cm) 12 1/2 (31.8) Nominal Impedance [Zn], ohm [per coil] 2 or 4 Power Handling Watts, Peak (RMS) 800 (400) Sensitivity [SPLo], dB @ 1W, 1m 86.7 Effective Frequency Range, Hz 25-500 Mounting Depth, in (cm) 6 3/16 (15.7) Hole Cut-Out Diameter, in (cm) 11 1/8 (28.3) Equivalent Volume [Vas], ft3 (L) 3.37 (95.37) Net Displacement, in3 (cc) 122.1 (2001) Moving Mass [Mms], oz (g) 5.52 (156.4) Magnet Weight, oz (kg) 47.05 (1.334) Amp: Power band width 400W + 400W (0.3%THD, 20Hz – 20kHz, 14.4V, at bridge connection into 4Ω / 200W × 4 (0.3%THD, 20Hz – 20kHz, 14.4V, at 2Ω / 100W × 4 (0.08%THD, 20Hz – 20kHz, 14.4V, at 4Ω Frequency characteristics 20Hz – 50kHz (+0, -1 dB) S/N Ratio 105dBA Input sensitivity 500mV – 8.5V / 10kΩ, [Center] 1.0V / 10kΩ Crossover frequency 50 – 200Hz, slope: 12dB/oct Size (W x H x D) 650 x 86 x 247/300 mm Weight 15 kg |
ok yes...it is very possible that they are wired wrong... you see you have a dual voice coil sub...that means it can be wired many different ways. first off, i need to know how many subs you have?
|
i have 2 12' subs.
|
|
Thanks a lot,that helped.
|
All times are GMT -5. The time now is 09:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands