Interesting new rear exhaust shrouds from R-magic for S1/S2
 

Check these out, they could really work for someone who has mazdaspeed front and sides, but not the rear. I can't tell about the quality, but what I would do personally is get the S2 bumper/taillights with these exhaust shrouds on my S1.

scroll down past the tow belt

AERO?RX7/RX8 ?????????? R Magic

I did not see a fender flare on that page. After the tow belt their is an exhaust shroud and after that side skirts. At the very bottom of the page is their widebody kit. Just in case I'm mistaken post the picture to what you are talking about.

you know what, I used the wrong terminology, it's an exhaust shroud lol, how noob. In their words "muffler garnish." Fender flares make quasi widebody kits, this is not that. Thanks for correcting me.

^ I saw this thread earlier and scoured up and down through their website looking for a flare..

Didnt matter though, i noticed it was new and spent a fair bit of time on it.

I wonder if you were able to cut out the reflectors in the shroud on the s2 model to allow you to run a s1 unmodified exhaust with the s2 bumper....

fyi japanparts doesnt have this part yet.

would love to find a exhaust tip delete trim for the right side for people running single exhaust tips out the left side

They do not list all the parts for every company they sell parts for. If you contact them for a quote on such a part it usually ends up listed on their site.

Not sure if this what you meant. Here is a one off custom bumper of filling in the exhaust shrouds. Both sides have been closed but could give you an idea what it would look like.

https://www.rx8club.com/members/neme...eck-lip-16.jpg

thanks, i was hoping for a swap out type of panel but i dont think they exist.

im just going to get some mesh screen that matches the lower trim design and mold it into the deleted side.

similar to this .

CCG Universal 6" x 36" Small Diamond Aluminum Grill Mesh Sheet Black Powder Coat | eBay

^ if you are going to modify the rear bumper to make a single look better, you might as well cut out the whole god damn thing and fabricate a diffuser.

I dont mind how my single looks.

:rolleyes:

^its been done about 10+ times, and it looks terra-bad every time when someone tries to put a mesh in there.

search for it.