Mazsport Cooling mod - does it work ?
07-03-2009, 04:28 AM
#76
You are right because it is just a fan and if it is sucking extremely hot air going in, well you get it.
But I have to say it does work and that I have gone to meets and my car will be the only one blowing cooling my car down nicely. I didn't know you had this mod...what else are you hiding.
But I have to say it does work and that I have gone to meets and my car will be the only one blowing cooling my car down nicely. I didn't know you had this mod...what else are you hiding.
The following users liked this post:
Kamal El (10-16-2018)
07-05-2009, 09:34 AM
#79
guys you can reduce temps well by adding a secondary radiator for less than $100--temps will never get over 200f( in the southeast at least)
this is the one I used
http://www.summitracing.com/parts/SUM-G4968/
olddragger
this is the one I used
http://www.summitracing.com/parts/SUM-G4968/
olddragger
The following users liked this post:
Kamal El (10-16-2018)
07-05-2009, 10:35 AM
#80
Registered
Join Date: Jan 2007
Location: NJ
Posts: 1,401
Likes: 0
Received 0 Likes
on
0 Posts
guys you can reduce temps well by adding a secondary radiator for less than $100--temps will never get over 200f( in the southeast at least)
this is the one I used
http://www.summitracing.com/parts/SUM-G4968/
olddragger
this is the one I used
http://www.summitracing.com/parts/SUM-G4968/
olddragger
07-05-2009, 03:59 PM
#81
mount down from the back edge of the front bumper support---use the return heater hose to feed
ithttps://www.rx8club.com/attachment.php?attachmentid=141710&stc=1&d=12468ht tps://www.rx8club.com/attachment.php?attachmentid=141711&stc=1&d=1246827 46227462
simple. big reductions in temps--notice also i removed the front bucktooth--you dont have too--but i like the look.
olddragger
ithttps://www.rx8club.com/attachment.php?attachmentid=141710&stc=1&d=12468ht tps://www.rx8club.com/attachment.php?attachmentid=141711&stc=1&d=1246827 46227462
simple. big reductions in temps--notice also i removed the front bucktooth--you dont have too--but i like the look.
olddragger
The following users liked this post:
Kamal El (10-16-2018)
02-12-2010, 08:33 PM
#82
Rotary engine addict
Join Date: Jun 2008
Location: Guadeloupe (FWI)
Posts: 303
Likes: 0
Received 0 Likes
on
0 Posts
i installed this mod about a week ago and everything was well.... except.... two times i have went out to start my car and the battery has been dead... i notice that when i get out of the car and shut it off and the fan starts to run ... when i go back out to start the car that it is sluggish to start and or does not start at all due to a dead battery ... anyone else have this problem?... its an 05 with the factory battery so i am assuming the battery is still good. thanks for the input guys
Just arrived me the same thing
02-21-2010, 04:36 PM
#84
hey olddragger nice setup, i have been thinking about something like this but mounted the way pettit racing does theirs by cutting a hole in the lower engine shield, what do you think about that placement? i thinking about that area mostly because i have a front mount IC
02-21-2010, 04:38 PM
#85
He's as bad as Can
02-22-2010, 10:53 AM
#86
Rotary engine addict
Join Date: Jun 2008
Location: Guadeloupe (FWI)
Posts: 303
Likes: 0
Received 0 Likes
on
0 Posts
Mazsport is no longer in business but another vendor sells a unit that looks very much like the Mazsport unit RaceRoots. But I have never used them, I have dealt with Summit and they are great.
but I do not know if they are still on business
02-22-2010, 11:06 AM
#87
i have one still on my car, it is not in use any more since i have ACCESSPORT, its just there becuase i havent changed the line back out t one piece.
I did work with cooling, noticed cause i have aftermarket temp. gauges in the car. never had any problems with dead battery problems though..
I did work with cooling, noticed cause i have aftermarket temp. gauges in the car. never had any problems with dead battery problems though..
06-04-2010, 10:17 PM
#88
Registered User
Join Date: May 2010
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Bringing old thread back from the dead.
I just installes a used control kit on my car I bought from a forum member. My question is whats the life span of the controller that is placed in the collant line? If that sensor goes bad do the Relays still trigger the fans or will the relays not activate at all?
I just installes a used control kit on my car I bought from a forum member. My question is whats the life span of the controller that is placed in the collant line? If that sensor goes bad do the Relays still trigger the fans or will the relays not activate at all?
08-18-2015, 05:27 AM
#90
New Member
Join Date: Apr 2015
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Mazsport RX-8 Cooling Fan Control Kit
Where can i buy this because everytime i go onto mazsport.net or try to find it i seem to never find it at all. please help I've been looking for while now and it sucks because i can't find it. 
08-18-2015, 08:13 AM
#91
Here ya go
Mazsport is out of business. This is the new company, owned by the same guy.
Cooling Fan Control Kit by RX-8 Performance | RX8Performance.com
Mazsport is out of business. This is the new company, owned by the same guy.
Cooling Fan Control Kit by RX-8 Performance | RX8Performance.com
Thread
Thread Starter
Forum
Replies
Last Post
