---

POWER WINDOW INITIALIZATION PROCEDURE
NOTE:
Initial setting must be performed for the switch of each window drive-side and passengerside.
If the following operations have been performed, initial setting is reset, and auto up/down
and two-step down operation are disabled. Therefore, performing initial setting is
necessary.
Negative battery cable disconnected or power window system power
supply fuse removed. (perform initial setting for the switches of all seats.)
Power window switch connector disconnected. (Perform initial setting for
the switch connected with the connector.)
Prolonged open/close operation of the power window main or sub
switches causes the circuit breaker to activate and automatic operation is
disabled.
1. Turn the ignition switch to the ON position.
2. Press the switch of each window and fully open the door glass.
3. Pull the switch of each window to the manual-up position to fully close the door glass, and
keep holding the switch up at the position for approx. 2 s.

---

---

---