Rx8 part out Series 1 heavily Modded
 

2004 rx8 6speed MT part out

BHR ign $275 (sold)

Spare tire kit $175 shipped (without tire)

rx8 series 1 axles $50 each prefer local pick up

Mazmart oil pressure regulator kit $25 shipped

Rotor housings $75 a piece plus shipping

Kyle Mohan ported side housings (non-bridge port) $150 a piece shipped

Stock Tapped oil pan for turbo set up has 5/8" I.D. welded bung for a barb fitting $75 shipped

I have 2 front engine covers with OMP's on them $100 a piece shipped

2 Pairs of weight C front and rear rotors $100 a piece plus shipping. Has oil control rings on them

2 Front covers $30 + shipping

2 intake manifolds and 2 extension manifolds. $50 a piece

Nav unit with center console $280 shipped

Head lights $120 each shipped they are the factory HID and will come with the wiring.
(Driver side sold)

Tail lights $85 shipped each

I have a hood $100 local pick up only

Trunk lid w/o spoiler $100 local pick up only

Driver side front Door $150 Local Pick up only (Passenger side sold)

Suicide doors $75 a piece Local Pick up only.

System will not allow me to add pictures yet will do so as soon as it allows me to

How many miles on the BHR ignition? Is the kit complete? Pics?

I'll take the rb duct and upstream o2 sensor

On the bhrI have put about 10k on it but bought it used with about 20 or 30k on it I can recall completely. It's been a while. I had it for about 3 years though.

$155 shipped

$155 shipped

Want the diff. Too far away. :(

Where in IL are you?

Lansing il at the border of munster in, and dyer.

Wow, what happened?

shortly after changing out the shitty injectors about 100 or so miles later 1 apex seal blew. I had a set of ra super seals. I tore the engine down today one of the front rotor apex seals was dark like it was getting burned up and smashed toward the tip. Will have to show picture to better explain it. I have gone through several rebuilds and over 4 years with it.

Parting out so I can have some money to build my speed 6 so I can have some real power to play with.

I'm very sad and hate to do this. I will get back in rotary either a series 2 with engine swap or an fc.

Cooling fan kit
 

Is the cooling fan kit still avail..

Dm sent

Yes the cooling fan kit is still available so is the mishimoto tstat. They work perfect together. My cooling temps never reached over 190 degrees. Really hot day it may hit 201 or so but it cools back down to 180 once the fans are engaged. Winter time you will average 169-174 but still get great cabin heat.

Do have the OE battery tie down?

Yes I have it how much are you looking to spend

I'm going to pm you

bump!!!!

Are you parting out the whole car or just the drivetrain? Interested in a few small parts. Any wheels?

PM'd

the whole car is being parted out. I still have the wheels they have no curb rash but do have some wear and tear. STicky weights are missing and tires have good tread wear about 6/32

how much for the wheels and tires? If you have a sunroof I would be interested in the overhead console with switches, the exhaust trim from rear bumper, and drivers headlight assembly? If the trans is good I might be interested in that too. My 2nd gear synchro is shot. ,

The Trans was sold today and picked up along with the series 1 diff. are you looking for just the control or the sunroof as a whole?

The console $150, Exhaust trim $25, my headlights are factory HID $175 for the LH.

Wheels and tires are good just need to be rebalanced since the sticky wheel weights came off. $300 fro the whole set if interested. Local pick up only if you want to go the route with shipping then you would have to be willing to absorb the cost for shipping.

I am looking for panel with reading lamps and sunroof switches. I am in Kansas City but will be going to Michigan in the near future. I would have made a special trip for trans and wheels but don't need the wheels as badly as I need the trans. When I go through next time I will check on to see what you might have left.