Pettit SC Kit, Rebuilt Ported 1.7L Screw
 

Freshly rebuilt and ported Pettit SC kit, purchased in May 2015 Moon Assad, this kit has been gone through and through by both him and me, and I have sourced all new and upgraded hardware. Also features a one off low profile mounted intercooler

Complete Kit includes

• Pettit SC Kit Rebuilt and Ported 1.7L
• Rx8Performance ACS with under tray
• DW300 Fuel Pump W/ BHR Install Tool
• Canton Racing SC Coolant Tank and Coolant Replacement Tank
• Bosch High Flow Coolant Pump
• Heat Exchanger Fan Kit w/ Tstat
• Block8Head Vent Gauge Pod
• GlowShift Water Temp Gauge

Kit includes all needed hardware and coolant and vacuum hoses using only AN fitting with Summit Twist Tite hose ends.

Kit is for sale for $7,000 OBO and is sold under the same premise as my car, as I do not have to part with either but my loss of ambition and time is making this a back burner project that will sit for a very long time. Wiil entertain serious offers not low ballers.

Also note this kit will be sold for $4,000 if purchased together with my Car.
https://www.rx8club.com/rx-8s-sale-w...5/#post4715506

Please call or email Ryan with any questions (716)3612410, Kpower@exactmm.com.

I do apologize I have very limited pictures currently while I am traveling but can get specifics upon request, or I will post more when I am back in the states later this month.

http://imagizer.imageshack.us/v2/640...913/IdH02F.jpg
http://imagizer.imageshack.us/v2/640...909/ydIFrW.jpg
http://imagizer.imageshack.us/v2/640...661/XZbkZU.jpg

Without reading through your build thread, what sort of power is this ported SC making at the wheels in your RX8?
$7,000 is a LOT of money...

No, that's NOT a lot of money for an RX8 SC kit. It's all about what you can afford, when considering FI for the Renesis.

Pettit SC Kit, Rebuilt Ported 1.7L Screw
 

Subbed for interest

This is a one of a kind custom pettit kit, featuring the kenne Bell 1.7L blower. It was never installed so I do not have numbers. It is also on the standard pulley and is expected to make 300-330WHP (depends on your tune and engine health). You can also source the high boost pulley from Pettit for increased performance.

Price is more than reasonable considering the rarity of these kits, coupled with the fact that it is not your average blower and has a fresh rebuild.

Motivated to sell by the end of the month, open to offers.

Deposit received, kit is on hold sale pending.

Sold

Congrats to the new owner

Wish I saw this