JDM Series II headlights
 

Gauging interest for a set of JDM S2 headlights that I'm just finishing up with restoring. The inside trim has been painted Chrysler black pearl and have had projector bulb reflectors added as well (reflects red in low beam bulbs when lights are off and outside light hits them, low beam light is completely unaffected - see example pic for visual explanation)
These will fit any USDM model S2 RX-8 or S1 RX-8 if you're doing a front end conversion
These lights were extremely hard to come by, but I am not looking to make a whole lot off of them, so I'm looking to sell them relatively cheap vs. the average price of one used USDM light
*two biggest differences between JDM and USDM is these have clear side reflective markers vs. the USDM orange/amber markers. There are also two sockets for signal lights in each housing, but you can either block one off, or splice the wires for the second light into the wires for your current single signal light in USDM models
*The current going rate (from what I can find) for one USDM headlight is $700 (new from Mazda is $1,045). The asking price shipped within the 48 US states is $800 for the pair
*I will be uploading updated pics once final polishing is done and no deals will be set in stone until the restoration is complete
Ships from Layton, UT, 84041https://cimg5.ibsrv.net/gimg/www.rx8...b1b1d3b763.jpg

https://cimg6.ibsrv.net/gimg/www.rx8...260c3a88f5.jpg

https://cimg7.ibsrv.net/gimg/www.rx8...6c6a494073.jpg

https://cimg8.ibsrv.net/gimg/www.rx8...1d6507fdb8.jpg

https://cimg9.ibsrv.net/gimg/www.rx8...747253baa9.jpg

https://cimg2.ibsrv.net/gimg/www.rx8...01da4323c2.jpg

I assume these have the cut-off pattern for "JDM" right hand drive?

If I remember right I switched the plates between the lights to address that, I did the same thing for my S1 lights on my cars which were off of an EU/UK RHD 8. They'll likely need a bit of adjusting, but that's easy to do (adjuster is located on the back of the light)