Feeler: Pettit race build, supercharger, S2 4.77 diff, S2 tranny, much more
 

As the title says I'm putting a feeler out the for basically all of my performance parts for the racecar. I can ship but, it will be VERY expensive...pick up preferred.
Please don't PM...my inbox is full...feel free to post here or txt 478-six97-2four72 for a quick response.

Pettit streetported race build engine (low miles) - $5000

Pettit Stage 2 supercharger with a few performance modifications - $7000

Series 2 transmission with syncro saver - $1500

Series 2 4.77 diff with upgraded cooling fins - $1000

LS2 MSD 8237 ignition system - $300

Remedy water pump and t-stat - $225

Mazdaspeed Strut bar - $200

Many more parts not worth posting right now until I am positive I will be selling. Will know very soon. :)
Stay tuned...

If I go threw a day of low will power that SC might end up on my CC, especially since I know where it came from.

All good parts and prices. May get the MSD kit.

PM'd

I am willing to take the strut bar off your hands next time you are in ATL.

is the strut bar front or rear?

Are the Mazmart water pump and T-stat new or used?

Would be interested in the stut bar as well, but there appears to be a line.

Should know today if this FS is for sure a go but, doesn't hurt to get some feelers out there and wanted you guys to have first dibs :)

MS tower strut is for the front w/ cylinder stabilizer

Water pump & t-stat are used

How much for the ms strut bar and stabilizer shipped to 45333?

I want that diff....

Posted From RX8Club.com Android App

Could you send me some info on the pettit buit engine? Pm or at my email jplunk1@hotmail.com thanks

Estimated miles on pump and t-stat?
Also, what are of Georgia? I'm in Canada, but have some friends in Atlanta who could do pick-up if you really don't want to ship.

Need a ms strut bar to replace one that i damaged... :(

Also forwarding this thread about the trans and diff...

Stephen

Shipping to L5R 2S6, Ontario Canada for the MS strut bar?

If Marcos doesn't take the mad ignition I will.

How many miles has the supercharger done? Have you got any pics, if you do could you send them to dlwilson_king@outlook.com I am quite tempted :)

Sent you a couple message. Hope you're getting them.

Hrm.. Moartor

It's all yours. :beer05:

Texting him directly is better

Thanks. I didn't realize he said his inbox was full.

Willing to separate the syncro saver?

Ok guys everything is sold except the diff, trans, engine, and supercharger

I'd rather not mess with anything besides the expensive stuff to be honest
Not worth the hassle as busy as it is right now

Hey, could you email me at shumster.ls@gmail.com? Would love to talk to you about that diff. Thanks!

Sale pending on the diff and supercharger
If the buyer falls through I'll do the engine and supercharger for $10k together
Retail on the engine alone is $8K

Hey so question this means MSD is up for sale since I see the kit going. What other parts do you have for sale that you didn't list?

The diff is MINE!!!

I bought my 8 with a blown engine and while searching for a replacement I stumbled across pettit racing. I think I'm just going to buy a replacement out of a wrecked 8 but planning on eventually swapping for a pettit so I'm just writing to pick your brain if that's alright :) how did you like it? did it perform to expectations? how was it's durability providing it's teken care of properly? Any feedback would be much appreciated!
-Clarence

P.s. I tried to pm but got an error message.

What are you asking on just the SC? If the deal falls threw.

It did fall through
Even carried it up to ATL and the guy met me there with $5k... $2k less than what we agreed on
I turned around and left

Diff is gone

A few details on the build
The engine is a Pettit Stage II streetported race build with 2MM FD Apex Seals, MANY modifications to the oil system, port cleaning, cooling jackets, Pettit cooling system mods and Pettit rotor housing mods which improve exhaust port cooling and minimize surface protrusion around lead plugs, main and rotor bearings clearanced to race specs, Micor finish on all critical surfaces, clean room assembled and static compression tested.
It has low mileage and pulls 20 inches of vacuum at idle. It was built to withstand forced induction and thrashing at the track. Pettit really stands behind their engines...I highly recommend you call Cam and talk to him about it. You won't be disappointed.
These engines retail from Pettit for ~$8K. I am asking $5K for the whole thing. I would even include the custom LOWER intake manifold. Runners shaped, smoothed, polished, ventilated, jet air deleted with reshaped port and VDI filled in, tubular header with 3" true merge collector. This is one of the only ones in the U.S. and a noticable difference in power.
If anyone wants the custom lower intake manifold and the longtube header/merge collector I'll let if go for $700

Pics of the header, I would be seriously interested in that.

Interested in the lower mani. Do you have pics?

Split the cost with you!

Great info slvrstreak thank you for the input!!

Posted From RX8Club.com Android App

Sounds like a deal Carbon8

If you are located in PA (Which for some reason I have it in my mind that you are) I will even come pick it up and save you the shipping cost!

Text me the details on it numbers the same, 7163612410.

Bump for a quality guy. I was the one that bought the diff.

Cheers

What does "Pettit Stage 2 supercharger with a few performance modifications" mean?

What modifications? Any idea how much to ship to Pettit?

I am sending my car to Pettit for an engine rebuild.

OP has not posted in 4 months, He has been around the forum tho and he never got back to me about his header so I am assuming he is no longer selling or he already sole everything.