Test for signal at coil connector
Using a multimeter, how would you test for signal at the gray ignition coil connector?
|
What do you mean by "test for signal"? What are you trying to do?
|
Originally Posted by 9krpmrx8
(Post 4806681)
What do you mean by "test for signal"? What are you trying to do?
New bhr coils, new wires, new plugs. I put an ignition tester on trailing 1 and got intermittent spark. Trying to figure out if the connector or ignition harness or possibly ecu is bad. |
Did you reset the NVRAM? Cat good?
use the troubleshooting guide here. http://foxed.ca/rx7manual/2003mazdar..._S01_0016.html |
To test the harness you need to follow the pinout and the diagram and test each wire all the way to the ECU.
|
The cat is new. Tried resetting the NVRAM, but will try again(disconnected the battery for a couple of weeks).
|
Also, was able to pull start it, but low on power. Wld not idle. Dumped alot of fuel into the cat as it started glowing after 5 minutes.
|
OH. Well testing the coil wiring is the least of your worries.
|
All times are GMT -5. The time now is 02:03 PM. |
© 2024 MH Sub I, LLC dba Internet Brands