rear chrome rotary crest, help...
 

Hi there everyone, i just recieved a rear chrome rotary crest but im in England and we have a rear foglight that is stopping me from fitting it, just wondered if the light can be removed for fitting the crest then re-fit the light? do any of you have the foglight and the crest??? thanks very much :)

got the fog lamp here and had to take the crest out first before installation.just use new tape and clean before reinstallation and you should be ok!the creast comes out pretty easy just pull on it slowly but firm at both the top and bottom real slow and it should come off easy(no punt and no flames please!) :GOOD LUCK! :)

but i wanted both??? is this not possible??

Try it I think Xr says it works, but last week Abbid said it didn't on a post in the for sale section.

If you want to sell the emblem let me know, I'm interested.

:spank: as per my post i have the rear fog light and the crest in the same hole(CENTER REAR BUMPER)no problem at all with the install or operation of this unit.bought it off line at auto parts warehouse i think.it was easy to install and took about an half hour to do.ran the wire's on the right rear vent(under the car inside the 1/4 panel)and tapped in on the brake,parking light and ground.no problem no fuss looks good and keeps most fools off your rear bumper! :Eyecrazy:

ahh thank you, mine is OE because its standard in UK, as are front number plates!!!

Look for Derwankel to see if he has any of his foglights left. I believe his fit with the aluminum rotary symbol installed.