OBD2 Ready Monitors - Can't get EVAP or SECONDARY to read ready
 

Anyone got any tips on this, All 6 other monitors read ready but for the life of me I can't get these 2 (evap, secondary) to come back on after Mazda did the 4206F Flash on my car. And of course I need to pass emissions and they allow 1 to be not ready but 2 will fail me.

I've tried to do the Mode 1,3, and 6 set procedures from the manual the best I could on the roads around here.

I'm reading no pending codes.

Anyone have this issue?

I'm currently having the same issue after doing an engine rebuild. The car is running great with no codes coming up. Any help is appreciated!

Just drive around enough and they will be ready.

There is supposedly a procedure for EVAP monitor to get ready, at least for some cars, but it's so complicated and precise that you will not realistically be able to do it unless you are willing to plan out the route and drive at 3AM.

I've put about 100 miles on it so far but I guess that's not enough. I'll continue driving it and hopefully it will work!