High 5 , Back flip , chest bump happy
UPDate
I over heated my 8 a while back , Had to get a rebuild budget together . Took engine out this week , took it to rebuilders today , We opened engine up . I was afraid of the loud POP I had heard when I put water in engine . I was very impressed with Micheal Edwards today he and his guys unloaded my engine and opened her up in about an hour , Cleaned up plates and rotor housings enough to judge the condition of each piece . Micheal said they were a 9 out of possible ten . :) All plates and rotor housings are in Very good condition ! No groves or flaking on housings , Water seal failure was evident !! Plates had acceptable minor wear . There was some bearing wear . So I am going to replace the e shaft , rotor bearings , main bearings , Heavy duty water seals from Pineapple , oil pan gasket ,oil control ring set . All from Pineapple From Atkins Apex seals and side seals , corner seals , and springs , upping oil pressure , complete gasket kit .. ect I believe my own eyes . With the XRT stage two clutch , in an RX8 raced over 150 hours and counting in endurance events , Redlined every gear ... Ill take the chance ! I have picked up a new factor hood and a factory front bumper to replace the Duraflex I can't wait to get her running again !!!! Big ass grin !! |
All times are GMT -5. The time now is 08:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands