Engine Cradel passange side stud size
 

Missing the stud on the upper cradle on the passenger side and its not the same size as the other bolts around it. Anyone know the length and size and pitch of the stud or can I just put a bolt in?
https://cimg1.ibsrv.net/gimg/www.rx8...8c262f9273.jpg

I just went through this. Pretty sure it’s M10-1.25 both sides. Seemed like I tried to use an exhaust stud, which is M10-1.5, and it wouldn’t go. My memory is not the best though, but you can check the thread with a bolt. I had the OE stud and never bothered to measure the lengths. You can measure the hole depth, the bracket thickness, and the flanged nut height to determine all of that thpugh. The easiest thing to do is to buy the OE parts of course.

It’s a motor mount bracket btw, not a cradle. :)

Also, would you please just start a help me I’m lost thread and put everything there rather than starting a new thread every time something pops into your head? You noobs always make a mess out of everything.

Any update if M10-1.25 was the right size? I was replacing my engine mounts today and the drivers side bracket had no bolts in it at all. Well there was a bolt in it... broken off inside the block.

I found the correct size bolts. They are M12-1.50 and an inch long