Car is hard to start
This may have been answerd before but search didnt find much. Just recently my 8 has had a hard time starting. Doesnt mater wether the car is warm or cold, It has been taking about 3-4 sec of cranking to start the car, and the battery does not sound weak. I have a little under 42k miles on the car, I just had the RP HighFlow Cat instaled. I dont see how that could have anyhting to do with it.
|
When were the spark plugs changed last? And have you ever changed the coils?
|
Mazda "says" everything was changed at 30k miles
|
Do you have the replacement high torque starter? How do you like the super cat / RB exhaust combo?
|
Originally Posted by Low Fly'n 8
(Post 2699591)
Do you have the replacement high torque starter? How do you like the super cat / RB exhaust combo?
Last time I filled up I put a little too much pre mix in, could that be the problem? |
If by 'a little' you mean three extra bottles, then that's not the issue.
I'd suggest it may be the starter, coils or plugs. |
2 things:
One, I see that you have a K&N intake. When was the last time it was cleaned and reoiled, and if it has been in for a while you might want to clean the MAF sensor? Two, if the car is idleing and running OK, then I would discount the sparks or coils as the problem, and I would think about high speed starter if you do not already have it. |
make sure that you have the updated starter.
|
Originally Posted by Haze
(Post 2701434)
2 things:
One, I see that you have a K&N intake. When was the last time it was cleaned and reoiled, and if it has been in for a while you might want to clean the MAF sensor? Two, if the car is idleing and running OK, then I would discount the sparks or coils as the problem, and I would think about high speed starter if you do not already have it. |
A clogged air filter can cause starting issues as well as idleing issues because of the lack of air. That happens with the stock filter as easily as a K&N.
Upgraded starter is a TSB from Mazda. I got it for free before my warranty ran out. Not sure if your car is part of the TSB VIN range. If it isn't part of the VIN range then you have the starter already factory installed in your car. |
Well I will clean my filter and see if that helps, I have to go to mazda to get a new shock put on soon, so I'll just ask them about it while I am there
|
coils fixed my car taking 4-5 seconds to start (as well as eliminating high rev misfires).. my car now starts in 1 second flat.
|
My car only takes an extra second to start if it's REAL cold outside...
|
Does anybody happen to know the name of the TSB. I'm having the same problem even after installing new coils, spark plugs, and cleaning my K&N filter
|
engine flood
|
Dealer rectified.
|
Originally Posted by cpo32
(Post 2702259)
Does anybody happen to know the name of the TSB. I'm having the same problem even after installing new coils, spark plugs, and cleaning my K&N filter
|
Thanks for the help...here's a link to the old TSB
http://www.finishlineperformance.com...48-06-1691.pdf |
Turns out it was a bad battery. The battery was only cranking at less than half power
|
All times are GMT -5. The time now is 06:55 AM. |
© 2024 MH Sub I, LLC dba Internet Brands