04 Rebuilt....wont start
Ok, I have done my best not to have to start a new thread but.....I am at a loss. I rebuilt my motor myself and now I can't get it started. I have done all the typical stuff and it all checks out, ie:
Good compression (not physically tested but getting loud "psssh" sound on all faces). Even squirted a bit of 2 stroke in there to make sure. Good spark (Tried 2 different sets of plugs and coils.) Unscrewed and block tested. Fuel (Good pressure and I can smell gas coming out of the exhaust) It comes out of the plug ports when they are taken out. I tried the de-flood method and no luck. I checked all the injector plugs and they look correct too. Like I said, I am at a loss. This is my first rebuild, so please don't bash me, but I was meticulous about it and went through a couple of rotors and housing before I got it right. It seems I am missing something, any help would be much appreciated. I can post a video if it helps. |
If it's a manual you could try tow starting it . If that doesn't work nothing will so at least you can rule out flooding as the issue .
|
Originally Posted by Brettus
(Post 4603302)
If it's a manual you could try tow starting it . If that doesn't work nothing will so at least you can rule out flooding as the issue .
|
Well, tow start was unsuccessful. I am determined to figure this out. I got one more thing to check before a pull the motor back out and that is the timing plate. It sounded like it wanted to do something in first gear but stalled as soon as I let off the gas and 2nd was a total no go. I am thinking I might have installed it backwards. Crossing my fingers that the excitement of it all caused me to be a little careless on the final steps of the install.
|
All times are GMT -5. The time now is 06:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands