OBD linking error
11-06-2018, 07:11 PM
#1
New Member
Thread Starter
Join Date: Nov 2018
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
OBD linking error
My fuses have checked out to be fine. My scanner turns on but when trying to communicate to the computer it says error. My problem is not the computer I have swapped it and still no luck.. .what should I do? Has anybody else had this problem before ? I didn't have any luck finding it In the forums.... 2004 rx8.
11-06-2018, 07:24 PM
#2
Has the scanner worked for you in the past? Is it OBDII?
For my scanner to connect I have to turn the key to the run position and sometime cycle it if it doesn't connect the first time.
Check device drivers as well. Sometimes they are outdated or not installed on the computer.
For my scanner to connect I have to turn the key to the run position and sometime cycle it if it doesn't connect the first time.
Check device drivers as well. Sometimes they are outdated or not installed on the computer.
11-06-2018, 08:55 PM
#4
New Member
Thread Starter
Join Date: Nov 2018
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
The car does run. The gas pedal doesn't do anything and the cluster doesn't work either... Powersteering is not working also I bought this car with a blown motor thinking I was just going to swap motors... Little did I know this car had other problems .
11-06-2018, 08:56 PM
#5
New Member
Thread Starter
Join Date: Nov 2018
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Has the scanner worked for you in the past? Is it OBDII?
For my scanner to connect I have to turn the key to the run position and sometime cycle it if it doesn't connect the first time.
Check device drivers as well. Sometimes they are outdated or not installed on the computer.
For my scanner to connect I have to turn the key to the run position and sometime cycle it if it doesn't connect the first time.
Check device drivers as well. Sometimes they are outdated or not installed on the computer.
Thread
Thread Starter
Forum
Replies
Last Post
