RX8Club.com

RX8Club.com (https://www.rx8club.com/)
-   New Member Forum (https://www.rx8club.com/new-member-forum-197/)
-   -   codes contradicting each other? (https://www.rx8club.com/new-member-forum-197/codes-contradicting-each-other-256466/)

morganwsmith 12-28-2014 02:48 PM

Engine trouble
 
04 rx8 130k. I got a few codes bank 1 lean cleared code. Then bank 1 misfire. Very heavy white smoke only twice within 2 months, smells like fuel no sweet smell. but not while codes come up. After driving from tx to ca made it to ca Driving at 4500 rpm. push gas peddle while driving. engine slowly revs down to 0. Would not start. After 10 min it would start and run fine no smoke. new spark plugs 2 weeks old, coil packs 1 year old. Car sounds like an exhaust leak at high rpm under load. Took it to two different exhaust shops. Both said they think it's coming from the engine. resonator has been removed. Aftermarket generic cat not gutted 1 year old. Oil is a little above full. Not full enough to be a concern I think. The dealership is lost. They just say replace the engine, coil packs, spark plugs, and wires.but can't tell me why. Spark plugs are brand new. They say because of the white smoke. No compression tests were done. Could this be an injector malfunction?

RIWWP 12-28-2014 02:49 PM

The engine shut off while driving with being able to restart it a while later, is classic fuel pump failure.

The white smoke might be due to a coolant leak failure leaking coolant into the engine though, a number of ways you can test.

morganwsmith 12-28-2014 02:57 PM

Thanks for the quick reply. Will check that fuel pump.

morganwsmith 01-05-2015 04:29 PM

Dealership ended up replacing the motor, spark plugs, ignition coils. I told them about the possible fuel issue no outcome yet. Still pulling the same code for misfire bank 1. They just told me with the new engine they have to program the crankshaft sensor. Or as I thought it was eccentric shaft. Any thoughts. I thought the sensor helps program it self.

9krpmrx8 01-05-2015 04:44 PM

Resetting the sensor profiles is needed after a new engine is installed.

RIWWP 01-05-2015 04:47 PM

And is something you can do without even bringing it back to the dealer. Search for "20 brake pedal stomp".

morganwsmith 01-05-2015 04:55 PM

Reset sounds better. Probably what they ment. Thanks. There wording has made me second guessing. Thank you for the reply.


All times are GMT -5. The time now is 11:07 AM.


© 2024 MH Sub I, LLC dba Internet Brands