RX8Club.com

RX8Club.com (https://www.rx8club.com/)
-   MW RX-8 Forum (https://www.rx8club.com/mw-rx-8-forum-31/)
-   -   Need a new engine/rebuild in the Chicago area.. (https://www.rx8club.com/mw-rx-8-forum-31/need-new-engine-rebuild-chicago-area-244079/)

iSki123 03-18-2013 03:34 PM

Need a new engine/rebuild in the Chicago area..
 
Well, it's finally time. My RX-8 is going to need either a FULL rebuild or a reman installed. I wish I could find someone locally to do it, as I have a time frame in which I need it installed and can't wait a month or more. Anyone in the Chicago area with experience in rebuilding these and pulling/installing the engines?

PS: I've got the 4 port 2004 Automatic.

- iSki123

alnielsen 03-18-2013 03:56 PM

You could try A-Spec in Schaumburg. They are the only rotary shop that I know of. Then there is Shook Motorsports in Rockford. He is a sponsor of our local rotary club EvolvChicago.org.

Of course, a Mazda dealer can do it. The rebuilt engine, installed, will be about $5000. Again, the local club is sponsored by Naperville Mazda. If you mention EvolvChicago to the service people, you may get a discount of some sort. I know we do on parts we purchase.

iSki123 03-18-2013 04:02 PM


Originally Posted by alnielsen (Post 4442190)
You could try A-Spec in Schaumburg. They are the only rotary shop that I know of. Then there is Shook Motorsports in Rockford. He is a sponsor of our local rotary club EvolvChicago.org.

Of course, a Mazda dealer can do it. The rebuilt engine, installed, will be about $5000. Again, the local club is sponsored by Naperville Mazda. If you mention EvolvChicago to the service people, you may get a discount of some sort. I know we do on parts we purchase.

You live in Dupage too, eh? I live right across St Andrews Golf Course.. I always see this yellow RX-8 when taking 59 to 64. I've always wondered if that was you.. Not a lot of running 8's in dupage these days..

Back on topic..

Contacted A-Spec and no call back from their place.. I'm stuck between a rock & a hard place right now. Mechanic I took it to wants it gone from his lot in the next couple days.

- iSki123

alnielsen 03-18-2013 04:10 PM

I'm further east, Villa Park. Go into my profile and you can see the pictures of my car. It's black. I do work for BP intermittantly, so I do get on 59. Just a little further south.

It's not running at all,eh. My engine runs. The car just needs work to make it road worthy again.

iSki123 03-18-2013 04:21 PM


Originally Posted by alnielsen (Post 4442199)
I'm further east, Villa Park. Go into my profile and you can see the pictures of my car. It's black. I do work for BP intermittantly, so I do get on 59. Just a little further south.

It's not running at all,eh. My engine runs. The car just needs work to make it road worthy again.

Ahh, I see. I've only seen around 3 RX8'S around my area, none really like to drive them in the winter though. :rofl:

My engine does run, but it leaks oil MASSIVELY when running. I believe it's the seals causing the engine oil to leak everywhere, it also stalls out. It never used to be like this, it actually gave out on me when I was installing new ignition parts. Took the darn thing out for a test drive and stalled right in the middle of an intersection on 59.. I take this car to Wilmot Mountain ( No clue if you know where that is ) very frequently since I work there. So I've got some miles on it now. Sorry to hear about your 8!

alnielsen 03-18-2013 04:43 PM

Does it just leak oil or does it blow smoke. The lines that go to the oil cooler (one cooler in your case) have a tendency to corrode and leak. I had to replace them on my car (6 spd manual). The cost to have them replaced would have been $1500. I got some used lines from a part out car for under $150.
I've never skied Wilmont. I have skied Villa Olivia, Devils Head, Cascade & Granite Peak.

iSki123 03-18-2013 05:21 PM


Originally Posted by alnielsen (Post 4442221)
Does it just leak oil or does it blow smoke. The lines that go to the oil cooler (one cooler in your case) have a tendency to corrode and leak. I had to replace them on my car (6 spd manual). The cost to have them replaced would have been $1500. I got some used lines from a part out car for under $150.
I've never skied Wilmont. I have skied Villa Olivia, Devils Head, Cascade & Granite Peak.

It leaks MASSIVE amounts of oil near the transmission area, when the cars running it sounds like a bogging snowmobile. I know that's a VERY harsh way to put it.. but it sounds extremely rough, deep & shakes when you turn. It takes a long time to crank over & start. I finally contacted Ryan..

Oh, a fellow skier. ^_^ I usually ski Wilmot, Alpine, Cascade, Four Lakes, Villa Olivia & Devils head.

Whitelightning 03-18-2013 06:06 PM

Red Mist Automotive in gilberts does rebuilds. PM me for the number the owner mike can help you

alnielsen 03-19-2013 02:34 AM


Originally Posted by iSki123 (Post 4442253)
It leaks MASSIVE amounts of oil near the transmission area, when the cars running it sounds like a bogging snowmobile. I know that's a VERY harsh way to put it.. but it sounds extremely rough, deep & shakes when you turn. It takes a long time to crank over & start. I finally contacted Ryan..

Oh, a fellow skier. ^_^ I usually ski Wilmot, Alpine, Cascade, Four Lakes, Villa Olivia & Devils head.

I haven't gone skiing in probably 5 yrs. Ryan of Shook? I know him well. He knows his stuff.


Originally Posted by Whitelightning (Post 4442274)
Red Mist Automotive in gilberts does rebuilds. PM me for the number the owner mike can help you

I haven't heard of Red Mist. If you decide to use them, let me know how it turns out.

iSki123 03-19-2013 12:03 PM


Originally Posted by alnielsen (Post 4442452)
I haven't gone skiing in probably 5 yrs. Ryan of Shook? I know him well. He knows his stuff.

I haven't heard of Red Mist. If you decide to use them, let me know how it turns out.

You should come to Wilmot sometime, we got another week left in the ski season!


I'm probably going to go with Ryan & a reman engine install, after I get the new engine installed I'll install a Sohn OMP mod or whatever it's called. That way I can inject FRESH 2 stroke into the engine instead of the dirty crankcase oil.

iSki123 04-22-2013 02:48 PM

It's been around 41 days since I haven't driven my RX-8, Ryan Shook was sent the check quite a while ago. The engine was received last week Monday, he said he can't install it for another week due to space issues. Or at least that's what he said... This guy is VERY slow...

alnielsen 04-22-2013 03:03 PM

I've had my engine replaced 3 times (under warranty). It took a month to get rebuilds from Mazda for my car. Then 2-7 days before the install was completed. This was at the Mazda dealer. It takes a full 8 hrs to replace the engine. The extended engine warranty didn't offer a loaner vehicle, so I was sharing my son's car to get to work (he worked nights at UPS).
I haven't talked to Ryan since last August. He is the only guy working in his shop and probably has several project he's juggling.
Good Luck

iSki123 04-26-2013 02:46 PM


Originally Posted by alnielsen (Post 4461266)
I've had my engine replaced 3 times (under warranty). It took a month to get rebuilds from Mazda for my car. Then 2-7 days before the install was completed. This was at the Mazda dealer. It takes a full 8 hrs to replace the engine. The extended engine warranty didn't offer a loaner vehicle, so I was sharing my son's car to get to work (he worked nights at UPS).
I haven't talked to Ryan since last August. He is the only guy working in his shop and probably has several project he's juggling.
Good Luck


My bad, I guess I got a little angry due to the lack of constant phone calls. The car is FINALLY towed out to his shop, he plans to do the install over the weekend. :bowdown:

traimbault 11-21-2013 08:01 PM

this is full of good stuff saving!

Posted From RX8Club.com Android App


All times are GMT -5. The time now is 08:11 PM.


© 2024 MH Sub I, LLC dba Internet Brands