loading the springs??

[RXSeven1]

hey guys, i just installed my s-techs and i followed the instructions on loading the front springs by leaving the a arm bolts loose in the front until i set the car back on the wheels. the front looks great..... the back however looks still a bit high. are you suppose to load the back springs also? the only major bolt i removed in the back was one control arm and i tightend it before i set it back down. could that be the cause?

This ad is not displayed to registered and logged-in members. Register your free account today and become a member on RX8Club.com!

[lesper4]

i didnt pre load my s-tech when i installed them and it looked great, not sure what the issue in.

[altspace]

I have the same and installed myself. You just need to preload the front. Note that the rear is only a .5" drop with the S-Techs. Also that within a month or so it will settle and be a bit lower.

Just in case anyone asks, my sig is not real.

[NgoRX8]

yea you cant do anything about the rear.

[RXSeven1]

hahaha, your the reason i even brought up this topic. i knew you had stechs and im like "wtf did i do wrong!!"

Originally Posted by altspace

I have the same and installed myself. You just need to preload the front. Note that the rear is only a .5" drop with the S-Techs. Also that within a month or so it will settle and be a bit lower.

Just in case anyone asks, my sig is not real.

[kevinD1226]

i bought tanabes and for some reason it looks like the front is higher.. let them settle then see

[dillsrotary]

you should get an inlinement soon