You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join RX8Club.com today!
Got mine Gias yesterday. It is awesome. I can't wait for the seat rails to get here so I could install it in the cars. Great service by Works Concept. Thanks Eric.
Got mine Gias yesterday. It is awesome. I can't wait for the seat rails to get here so I could install it in the cars. Great service by Works Concept. Thanks Eric.
Glad to see you like it, and the rail should be following shortly.
I had a full Spec-Miata-type roll cage that was fabricated and installed in my Miata. I had issues of clearing the roll bar with a standard seat or even the Sparco seats I had before.
I switched to the Low Max VIOS III seats with the Type LF Rails from Bride and they were significantly lower. About 2" and I no longer had an issue with the helmet clearing the cage.
Great seats......Eric....you'll see my order as soon as I take care of my ignition issues. I would probably go with the VIOS III seats again as they were SOOOO comfortable when compared with the Zeta III seats.
I guess it was the shape....
__________________ 2005 Mazda RX8 VR: Mazdaspeed V2 Dual Exhaust AEM CAI, Burnout KD-IV Front Lip (painted VR), JIC FLT-TAR Coilovers 1993 Mazda Miata: Crate motor from Mazda, Port and polished head and intake manifold from Flyin' Miata, BSP support braces, H&R Race, Tokico shocks, RSR Exmag GTII exhaust, Mazda Comp test pipe, MS PNP9093, Innovate LC-1 Wideband, Fuji Racing 45mm IRTBs, RS Aizawa fuel rail, and more........
I had a full Spec-Miata-type roll cage that was fabricated and installed in my Miata. I had issues of clearing the roll bar with a standard seat or even the Sparco seats I had before.
I switched to the Low Max VIOS III seats with the Type LF Rails from Bride and they were significantly lower. About 2" and I no longer had an issue with the helmet clearing the cage.
Great seats......Eric....you'll see my order as soon as I take care of my ignition issues. I would probably go with the VIOS III seats again as they were SOOOO comfortable when compared with the Zeta III seats.
I guess it was the shape....
Yes, those wanting the lowest seating position with a drop in install, BRIDE is the way to go. Thanks for the feedback.
Thanks for all your help for getting the seat & rail to me so quickly. The seat fit the 8 perfectly. With couple of inches of additional head room, it is much easier to drive with a helmet on. And the seat holds me in the car through corners like a dream. I am going to have so much more fun at the next DE. Great product & great service!!
Thanks for all your help for getting the seat & rail to me so quickly. The seat fit the 8 perfectly. With couple of inches of additional head room, it is much easier to drive with a helmet on. And the seat holds me in the car through corners like a dream. I am going to have so much more fun at the next DE. Great product & great service!!
Thanks for the feedback about the amount of headroom you gain. Its quite a bit, and BRIDE is really the only bolt on setup that give you that much room.
Linear Mode
