You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join RX8Club.com today!
i was pondering the idea if it was possible to some how to install angel eyes around our projector front, If you look closely there is a cap around the the projector. Perhaps it is posible to install angel eyes and wire them to the parking lights. Anyone else think of this. Or even if its possible?
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on RX8Club.com!
[SIGPIC][/SIGPIC] 2004 MT BB/ RX7 store mid pipe/ MazdaSpeed duel sport catback/ ZEX N20/ BHR throttlebody/ ACT streetduty clutch/ ACT prolight flywheel/ BHR ignition/ Progress Tech front and rear sway bars/. Megan track coilovers/ XXR 522's black/ Nitto NT05s/ GTSPEC 6 point strut tower bar/ BHR radiator/ AEM CAI/SIEBON CF front lip/BuddyClub grounding kit/AFE short shifter/ AP MM TUNEto come- RE MEDY water pump.
I baked my alero headlights, used the lowest setting and checked them every 5 minutes. They will hold up better than you think, and just used a good quality silicone to seal them back up. Make sure you seal them well or you WILL get condesation in your headlights!
I actually succeeded on taking the whole housing apart with a heater gun for about 20 minutes... and the headlights were from my 8 when it was in a hit and run accident =/... came in handy thats for sure lol...
Yea just bake the headlight around 150c in your oven make sure your oven door is open. And check it quite often. I was going to make my headlight angel eye but I decided not do it because of my country road rule.
i don;t know if this helps but here is some picture of the Dissembled headlights http://s163.photobucket.com/albums/t...inrt/?start=40
There is lots of cars faster than the RX-8 , there are no cars more enjoyable than the RX-8
I baked open my headlights on my RSX to paint the reflectors. I used the lowest setting on the oven, then the heat gun for any of the tabs that were still stiff. I can't comment on the longevity of the mod since the headlights and the rest of the car were scrapped after meeting a telephone pole at 60mph
Also a friend of mine had angel eyes professionally installed on his R1 and they had to re-install them 3 times because the rings kept breaking. Both physically and electrically. They couldn't take the vibrations. He finally had them take them out.
Well yea these headlights cost 995.00 each if you have the HID version, i had both of mine replaced by the dealer! Good luck if you bake your headlights, there go two grand! Just be careful for all DIY guys!! You guys can elso go to www.automotivelightstore.com, they offer the halo rings for the RX8 for 150.00, also on ebay[http://stores.ebay.com/Advanced-Automotive-Concepts] selling so far for $100 for 4 halos, two small rings and two small ones! They can also install them for $150! They also have a video on youtube.com on how to install them yourself! Your welcome guys!