rudi888

My friend's Rx8 just change full amuse exhaust system..(Header to exhaust tube).. After installation, the 8 becomes lack of power compare to stock. What happen? His 8 is manual n pre facelift model...Desperately need inputs from all seniors here. Thx

9krpmrx8

iTrader: (46)

So you replaced the header, the midpipe (cat), and entire rear section? Did you block off the air pump?

StealthTL

iTrader: (1)

Any 'check engine' lights on?

Could be damage to the primary O2 sensor (the one on top of the header.)

rudi888

@9krpmrx8: Nothing done to the car yet.. only installing the exhaust systems only...

@StealthTL: I will check w/ him soon whether there is any Cehck engine lights illuminating...

Thx for the very useful inputs guys...

rudi888

@9krpmrx8: Nothing done to the car yet.. only installing the exhaust systems only...

@StealthTL: I will check w/ him soon whether there is any Cehck engine lights illuminating...

Thx for the very useful inputs guys...

Old Rotor

Are all sensors still being used? Check everthing then reset PCM.

rudi888

No CEL at all...
everything's fine.. except for the lack of power.....