Lower Control Arm Problem - Picture Attached
#1
Lower Control Arm Problem - Picture Attached
I have a 2004 RX8, 6spd manual. I removed the brake caliper and removed the upper control arm (leaving the rotor attached to the lower control arm supported by the lower boot). The lower boot then separated itself (see the picture). I did this procedure on the other side (while removing the stock struts) and it went fine.
My question is, can the separated boot (not sure of its correct name) be put back together and function normally? If yes, how would I go about doing that? Or do I have to buy a new lower control arm (which I am hoping I don't)?
My question is, can the separated boot (not sure of its correct name) be put back together and function normally? If yes, how would I go about doing that? Or do I have to buy a new lower control arm (which I am hoping I don't)?
#2
Registered
Join Date: Jul 2004
Location: Northern California
Posts: 2,196
Likes: 0
Received 0 Likes
on
0 Posts
Not sure if this helps. Is this the part you are looking at?
http://www.finishlineperformance.com...5-08-1948a.pdf
http://www.finishlineperformance.com...5-08-1948a.pdf
#3
Not sure if this helps. Is this the part you are looking at?
http://www.finishlineperformance.com...5-08-1948a.pdf
http://www.finishlineperformance.com...5-08-1948a.pdf
See my reposted picture with illustration.
Last edited by RX8Prodigy; 01-05-2011 at 08:07 PM.
Thread
Thread Starter
Forum
Replies
Last Post
xAgyex
Series I Trouble Shooting
19
11-13-2023 07:51 AM
WingleBeast
Series I Wheels, Tires, Brakes & Suspension
22
05-23-2016 09:22 PM
Sifu
RX-8 Parts For Sale/Wanted
3
08-30-2015 10:51 PM