How do u switch out the small light bulbs in the front.
#1
Registered User
Thread Starter
Join Date: Apr 2004
Location: virginia
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
How do u switch out the small light bulbs in the front.
I want to switch the bulbs in the front of the 8 but i dunno how to take them out. Has anyone done it before and can give me some input? thanks
#2
no more 8
Join Date: Aug 2004
Location: Mid-Cities area, TX
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts
#3
Registered
Join Date: Apr 2004
Location: Fort Smith, Ar
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
we tried the search button and your help was no good...
Originally Posted by Mr. Ed's rx-8
#4
Metatron
iTrader: (1)
Bulbous....
I take it you mean the ones closest to the centre of the car....
The drivers side is easiest, start there. The bulb doesn't go in from the back (good, since that would be worse to change), they go in from the engine side of the housing, at an angle.
Take off the fusebox lid, then look into the area behind the headlight, you can see the bulb holder, if you have nimble fingers it will twist out o.k. (lefty loosey!)
The pass side is a little more difficult, and you might have to take off the lid of the computer, depends on your hand size. By the time you do the drivers, you will know! Careful to pull them straight back, they are a push-in type and if you are rough they will fall into the housing....don't ask :D .
If you have huge hands, or want to make it an all day task, you can take the wheel lining out, and go in from the back, but since they are on the inside, it's not much easier.
S
The drivers side is easiest, start there. The bulb doesn't go in from the back (good, since that would be worse to change), they go in from the engine side of the housing, at an angle.
Take off the fusebox lid, then look into the area behind the headlight, you can see the bulb holder, if you have nimble fingers it will twist out o.k. (lefty loosey!)
The pass side is a little more difficult, and you might have to take off the lid of the computer, depends on your hand size. By the time you do the drivers, you will know! Careful to pull them straight back, they are a push-in type and if you are rough they will fall into the housing....don't ask :D .
If you have huge hands, or want to make it an all day task, you can take the wheel lining out, and go in from the back, but since they are on the inside, it's not much easier.
S
Thread
Thread Starter
Forum
Replies
Last Post