Help with scan data from torque pro
#1
Registered
Thread Starter
Help with scan data from torque pro
Used my torque pro app today as I've got a fault and these are the two things it throw up.
Mid $bo tid $99
Min 25.197% max -74.383%
Current -79.938%
Mid $fo tid $ cc
Manufacturer defined mid
Min 8,273 max 4
Current 52.464
Mid $bo tid $99
Min 25.197% max -74.383%
Current -79.938%
Mid $fo tid $ cc
Manufacturer defined mid
Min 8,273 max 4
Current 52.464
#5
Registered
iTrader: (2)
Join Date: Oct 2007
Location: Pacific Northwest
Posts: 16,684
Likes: 0
Received 240 Likes
on
110 Posts
big rooster, not quite true.
What are you trying to accomplish? If you have a CEL on, for example, you simply picked the wrong part of the app.
Try clicking the Fault Codes section instead: (randomly grabbed web image to show the screen)
The vehicle test (often referred to as mode 6 test) can give you a lot of information, but it doesn't always mean anything by itself and none of the tests mean anything without proper Mazda RX-8 specific labels.
What are you trying to accomplish? If you have a CEL on, for example, you simply picked the wrong part of the app.
Try clicking the Fault Codes section instead: (randomly grabbed web image to show the screen)
The vehicle test (often referred to as mode 6 test) can give you a lot of information, but it doesn't always mean anything by itself and none of the tests mean anything without proper Mazda RX-8 specific labels.
#6
Registered
Thread Starter
Hi thanks for the reply .. I've done a fault check and have a code I'm putting the fault down to air leak or coils but I cleared the fault from the ecu to see if it came back but no return so far but I just put the test scan on just to see what the sensors were reading but when two of the checks came back with a fault I just didn't understand what I was seeing .
Thread
Thread Starter
Forum
Replies
Last Post