can anyone with multimeter help me out?
#1
Unregistered User
Thread Starter
Join Date: Apr 2006
Posts: 824
Likes: 0
Received 0 Likes
on
0 Posts
can anyone with multimeter help me out?
This may be too much to ask but here I go..
I'm wiring up a TCS for my rx8 that didn't have TCS.
I need the combined sensor information.
It's located over the transmission tunnel in the rear of the car (driveshaft tunnel). would be nice if you already have the interior apart.
I need to know what voltage "F" position reads when the car is on.
I would also like to confirm that "B" is 12v when ignition is on, and "A" is contiguous with chassis ground.
I think "E" and "C" are the signals. No idea what "D" is.. I think it has to do with CAN bus or diagnostic testing.
Thanks in advance.
I'm wiring up a TCS for my rx8 that didn't have TCS.
I need the combined sensor information.
It's located over the transmission tunnel in the rear of the car (driveshaft tunnel). would be nice if you already have the interior apart.
I need to know what voltage "F" position reads when the car is on.
I would also like to confirm that "B" is 12v when ignition is on, and "A" is contiguous with chassis ground.
I think "E" and "C" are the signals. No idea what "D" is.. I think it has to do with CAN bus or diagnostic testing.
Thanks in advance.
#2
Unregistered User
Thread Starter
Join Date: Apr 2006
Posts: 824
Likes: 0
Received 0 Likes
on
0 Posts
got the info. Bosch was surprisingly helpful.
Reference voltage is generated by the sensor and that just needs to be connected to the ABS/DSC box or in my case, left disconnected since I'm using haltech.
Others I have listed are correct.
Reference voltage is generated by the sensor and that just needs to be connected to the ABS/DSC box or in my case, left disconnected since I'm using haltech.
Others I have listed are correct.