Porting problem
#1
Porting problem
Hi
I ported engine RB street templates and polished
The car does not go to idle.
Idle 1000
MAF shows 7g \ s
MAF without car rides but heard gunshots
With MAF car stalls when trying to enter the idle
What do I do?
What fuel map need to change?
I ported engine RB street templates and polished
The car does not go to idle.
Idle 1000
MAF shows 7g \ s
MAF without car rides but heard gunshots
With MAF car stalls when trying to enter the idle
What do I do?
What fuel map need to change?
#2
Hard to say based on just your explanation. Idle MAF g/s seems high, but its been years since i've have looked at that. What else is done to the car? I have seen ported engines not want to idle, have you done a compression test? What is it? Is everything else up to par maintenance wise, etc? With the Mazda edit you can raise the idle speed.
#9
Driving my unreliable rx8
A good healthy engine should run with out any one of the wires. Im still pretty sure it is wiring. But it is a good place to look.
Also why are you starting a new thread on the same subject? Everyone helping you starts off from the beginning again.
Also why are you starting a new thread on the same subject? Everyone helping you starts off from the beginning again.
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM
1.3_LittersOfFurry
Series I Trouble Shooting
9
09-22-2015 01:54 AM