slash128

Cruisin' with Harlan

Harlan

iTrader: (3)

Ok, brief update. Been working 60+hrs per week and haven't had the time for much on the car. Just got a large 3d printer and did some test prints with carbon fiber reinforced nylon. Gonna print a new intake piece out of the CF nylon and probably use it in a lot of other places on the car. Great material.


Need to get the Isuzu coil mod working or bust. PPP is too much of a pain the the butt for analysis and detonation is just as important (or more important) overall. Working on a new plan if I can deal with the EMF off the Isuzu coils.


Oh and tried to start the car yesterday and it would not start at all... Dunno if it's the teensy/ corrosion on the board from when it got rained on, or ignition coil failure again. Will post more when I get this darn thing running again.

Harlan

iTrader: (3)

Car still won't start. Finally getting enough time off to catch up with the rest of the world. Printing out mock up intake pieces and working my way through prototyping in ABS. Getting ready for a 20hr print for the new intake, but I'm getting the hang of the design software.

Still need to bench test the Isuzu coils again, but haven't had a clean desktop since early February, so gonna have to clean up a bit first. Moving forward for the first time in a couple of months though.