rx8phase1

iTrader: (1)

i've been on the internet for 4 hours searching for this but i still cant find someone who has them in stock and sells them i've seen some but they look ugly and they cost like $300 wtf so can someone help me or redirect me to a thread that i have missed thats answers my question

tiltmode43

iTrader: (15)

renesisSE3P has a guage pod setup similar to that, ask him

rx8phase1

iTrader: (1)

thanks

SiLVeRE8

iTrader: (8)

you can get it at rx8strakes.com

N rider89

^they only sell the lotek type of gauge pod that goes on top, and its more expensive on their site.

http://www.gaugepods.com/mazda.html

rx8speeddmon

iTrader: (4)

The picture he showed was of the lotek pod... which your right, it does go on top. You can also find it occasionally on e-bay, that is where I got mine.

rx8phase1

iTrader: (1)

^^ thanks i'll check ebay i dont feel like spending more than $100 on this

rx8phase1

iTrader: (1)

n rider 89 thanks ima be buying them from there.just wondering what are the clamps for what do you clamp them to?

rx8speeddmon

iTrader: (4)

After you remove your center dash piece you need to cut a hole in it. You then glue the pod to it and clamp it down until the clue drys. It will look like this when done.

rx8phase1

iTrader: (1)

damn that looks so nice so these gauges do they read for example fuel/voltage w some wire that goes to the source or a signal

rx8phase1

iTrader: (1)

hey i just noticed u have something connected to the airbag light

alz0rz

iTrader: (41)

airbag light? looks like a cigarette lighter...

rx8phase1

iTrader: (1)

yeah on my 8 thats the airbag light for the passenger side it lights up saying airbag off when a certain amount of weight is on it i think if its under a hundred pounds

MisplacedRotors

before 06 at least in the states in the it was just a circle in the dash

rx8speeddmon

iTrader: (4)

Yes, it is just an accessory plug for the radar detector... haven't gotten around to hard-wiring it yet. The gauges I got are oil pressure, oil temp, and coolant temp. The gauges are from prosport, which many on the site have. I looked at past transactions and lotek on ebay login name is lotekengineering. The gauges are from http://prosportgauges.com/.

rx8phase1

iTrader: (1)

i would get the voltage/fuel and the third im still deciding our car already has an oil pressure gauge and temp.so what do you guys think my third should be?

TheWulf

iTrader: (4)

^ don't rely too much on the stock gauges. they aren't very accurate -- especially the oil pressure gauge

rx8phase1

iTrader: (1)

^ yeah my oil pressure one has always been in the same place a lil over the middle hopefully thats a good thing lol

rx8speeddmon

iTrader: (4)

All that shows is if you've got pressure or not.... I like watching mine bounce up and down w/ the throttle.

rx8phase1

iTrader: (1)

^ haha thats bada$$ ima get the oil pressure gauge for my third then....one more thing on a scale from 1-5 how hard is the install im asking cuz im afraid of doing anything that includes cutting or making holes in my car

rx8speeddmon

iTrader: (4)

For me about a 3. My temperment isn't suited to this time consuming task...... at times I just wanted to use a hammer. It is just basically pulling wires and keeping them straight, but I read through other install threads to find the wires to tap. GL w/ your install.

rx8phase1

iTrader: (1)

so these are the 52mm right?