You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join RX8Club.com today!
Hey guys, Well I have been installing radios and what not for years now and I ran into a problem. Now I feel like this is an obvious answer but im lost.
I am trying to Solder the audio cable to the left and right terminals but I dont know what goes where.
I am using a 6ft dual ended aux cable. So there is a 3.5 mm jack on both sides, I'm not using an RCA cable. So I chopped one end off and stripped it down. So right now I'm left with 3 wires.
White, red, and blue. Now I'm assuming that white is negative, red is positive, and blue is the ground. So the main question is what goes where? Reading his tutorial he just says to "solder them up" but what to where!??
IF I go with his route and get an rca cable with the left and right audio outputs, How would I go about soldering those wires up? He says to join the negatives togather which makes sense then would leave the right positive and left positive alone. So where do the negatives and positives go?
Please help, I would like to finish this project tonight. Thanks!!
Matt
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on RX8Club.com!
Ok, update, The aux cable has a red wire, white wire, blue wire, and the steel surrounding which is the ground. The red and white are the left and right channels. What the hell is the blue wire??!?!?!
Since you have another 3.5mm jack, why not cut the insulation around the jack and see where the wires are soldered to.
Pretty sure the tip is left ch, ring below is right ch, and lastly ground (at least that's what a few Google searches resulted).
__________________ Current Mods: RB REVi Intake & Ram Air Duct, AP Catback Exhaust, MazSport DR Midpipe, AP Pulley, BHR Ignition Coils, BHR/SPEC Flywheel, ACT Counterweight, Exedy Stage 1 Clutch Kit, HD Release Bearing, AccessPort w/MazdaManiac tune, REmedy Thermostat & Water Pump, AFE Short Shifter, Lotek Pod with ProSport Gauges, Axxess iPod Adapter, Illuminated Shift Knob, Bridgestone Potenza RE760, OPTIMA 35 RedTop Battery. Oils: Engine= Royal Purple 5w30, Trans= Redline MT-90, Diff= Redline 75w90
Trying to pull apart a jack isn't really as simple as it sounds. the wires to actually connect to the jack housings directly. they connect to wierd paths and it really hard to follow lol.
I tested the wires on my headphones and they work fine with out the blue wire, So I'm just going to chop the blue off and solder the other three on.
Well I got it all soldered up. And to say the least I am very impressed with my work! These are extremely small terminals and wires so I am happy with the way they came out. I'm sure people could make it look much nicer, but Im satisfied. Then to keep all the wires mounted, I just put a thin line of superglue holding them down. The second picture is with a penny, just so you get an idea of how small this really is!!
I wasn't going to bother posting any of this up, But I figured I would just incase somebody else was bored and wanted to futs around with their car. The more that comes up in the search the better!
Having trouble with Ipod Hack
Linear Mode
