Rotary-RX8

iTrader: (1)

I just got a hold of an authentic mazdasped bumper. Fits perfect !!! Except for the corners the the bumper meets the clear corners. They pop out just a bit. I know for a fact its authentic (i know how to tell lets not discuss that). But maybe i installed wrong. Also rear ended a guy like a few months back .. it was a light tap near my passenger side front. And the headlight there seems to be a bit loose like i can push it in a bit.


When i push in the corners they dont go in. The brackets seem to be in good condition. Any ideas ?

staticlag

Aside from pulling everything apart and measuring clearances, you could just squirt some clear RTV silicone behind it so it holds.

Rotary-RX8

iTrader: (1)

Thanks i pulled it off. I pushed the corners flush hard held it there while tightening the clear corner. The other side is cause the bracket holding the headlight broke when i hit the guy. So its kinda loose which is why that side isnt flush. The headlight sinks in a bit bothers me but i fixed it best i could thanks !!