You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join RX8Club.com today!
I have the sides for the mazda apperance package, I used double sided tape to hold the tops on, but it just keeps letting go.. im using 3M stuff. What else can I use to hold them on?
thanks alot
Ian
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on RX8Club.com!
lol i used 3m double sided too but mine holds like a champ...
did you clean the area before putting it on tho? like some alcohol and stuff.... and make sure its on the right place like all line up....from that u shouldn't get any issue like these....
__________________
2007 SB GT, COBB/PPO2 tune +10 whp, axial flow short shifter, MS CAI, MS dual can exhaust, tein coilovers, AP pulley, fno1r-c matt black +38, clear corners, led side markers, led parking, tein hood dampers, tint. -- maserati
alright thanks
I did have the holes. but I bought the car with other side skirts on and didnt realize the holes were already there... it still doesnt hold tight to the top but I willl try the rubber cement to help thanks
apperance side question
except ill be the ugly 1 until i get some plastic surgery on the outside 
Linear Mode
