CEL Masking
#1
Mile High Eight
Thread Starter
CEL Masking
The thread about CEL vs Ready state prompted me to want to clarify what I see as a very easy question, but I don't fully understand.
With the AP and ATR, I have all of my engine codes active (all check boxes are checked), however, I am not receiving a CEL for my missing cat. I have been running without a cat for over a year.
Can someone explain if this is normal, or am I missing something?
Thanks for your help.
With the AP and ATR, I have all of my engine codes active (all check boxes are checked), however, I am not receiving a CEL for my missing cat. I have been running without a cat for over a year.
Can someone explain if this is normal, or am I missing something?
Thanks for your help.
#3
Mile High Eight
Thread Starter
While you may find this thread unnecessary, I do not. Contrary to your assumption, I did search. Both using the internal forum search and directly through google (site:rx8club.com).
I could not find an answer to my particular question, because it would appear that my situation is working in reverse to the normal.
All the threads I did find show steps on how to mask an existing CEL. I have no CELs masked, and yet I have no CEL displayed even though I have a catless midpipe installed.
So if you happen to have an answer, I would appreciate you educating me.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Shankapotamus3
Series I Trouble Shooting
28
03-14-2021 03:53 PM
Evan Gray
Series I Trouble Shooting
0
09-26-2015 12:30 PM