DIY: How to make a device mount for free
07-31-2008, 03:13 PM
#1
I zoom therefore I am.
Thread Starter
DIY: How to make a device mount for free
So I got my MM AP the other day and love it. But it does get a bit tricky holding the AP while driving. I was going to purchase a mount from Proclip usa but inspiration struck me.
1. Find something made of black plastic with a 90 degree bend in it. I had the lid for an old set of snow chains.
2. Cut out a section of the lid, shown in the first pic.
3. Trim the piece of plastic to fit nicely on the back of the AP. I had some left over velcro like stuff on my workbench. It's not velcro but made of plastic and holds like crazy.
4. Simply push the now mounted piece of plastic between the vent and the dash trim.
Total cost = 0
Total time = 5 mins
1. Find something made of black plastic with a 90 degree bend in it. I had the lid for an old set of snow chains.
2. Cut out a section of the lid, shown in the first pic.
3. Trim the piece of plastic to fit nicely on the back of the AP. I had some left over velcro like stuff on my workbench. It's not velcro but made of plastic and holds like crazy.
4. Simply push the now mounted piece of plastic between the vent and the dash trim.
Total cost = 0
Total time = 5 mins
Last edited by laythor; 07-31-2008 at 03:18 PM.
08-27-2008, 01:37 PM
#2
Administrator
iTrader: (7)
brilliant!
08-27-2008, 02:12 PM
#4
Administrator
iTrader: (7)
maybe....
08-27-2008, 02:39 PM
#6
Administrator
iTrader: (7)
omg!! it's Newcastle! 
08-27-2008, 02:39 PM
#8
Administrator
iTrader: (7)
make me one. kthanxbye
Thread
Thread Starter
Forum
Replies
Last Post
bulletproof21
RX-8 Parts For Sale/Wanted
6
10-20-2015 08:53 PM
RenzoRx-8
RX-8 Parts For Sale/Wanted
1
08-25-2015 10:29 PM