cel
#1
cel
hey guys i just installed the agency power lightweight pulley for my ecentric shaft now my car is throwing a check engine light for misfire cylinder 1 any fix for that?
#2
Unregistered User
iTrader: (1)
Join Date: Oct 2004
Location: Spring/The Woodlands
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
I had that happen to me when I put mine on. I also had one pop up when I had my engine replaced.
All I had to do was take off the pulley, clean the mating surfaces really well, and replace it making sure it sat perfectly on the shaft. Make sure that it's not off kilter the slightest little bit because the shaft position sensor is very picky.
I think I also did all of the ecu resets.
Good luck.
All I had to do was take off the pulley, clean the mating surfaces really well, and replace it making sure it sat perfectly on the shaft. Make sure that it's not off kilter the slightest little bit because the shaft position sensor is very picky.
I think I also did all of the ecu resets.
Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
Shankapotamus3
Series I Trouble Shooting
28
03-14-2021 03:53 PM
Evan Gray
Series I Trouble Shooting
0
09-26-2015 12:30 PM