Phish806

iTrader: (4)

Year: 2005
Make: Mazda
Model: RX-8
Price: $15500
Mileage: 79000
Color: Nordic Green
Private or Dealer Listing: Private Listing
Location (US State/Canada/Int): IA

Well guys, the time has come -once again- that i am thinking of selling my Rx8. It was my daily driver for a couple years then slowly turned into my project car. I have again ran into a few issues so will sell it if i can get the right price for it.

The car, as it sits now, has a cracked side housing on the front rotor. Due to this fact, this sale can go one of two ways. I will take $15500 as the car sits or $18000 if i repair the motor and have it in good MECHANICAL condition. (i will not pay for the tune and dyno time as we all know that adds up real fast.)

The incident that lead to the motor getting a crack was believed to be on the dyno durring the tuning session. Tuner was Steve Kan and all was going well. About an hour into the session the throttle stuck open and hit the limiter before the car could be shut off. The boost spiked to 18lbs during this and we believe that this was the incident that caused the crack. My goal for this build was to break the 400whp mark and i still believe that would be very easily done. All unfortunate for me, but could make out to be a decent deal for others.

Now, on to the car.

2005 Touring RX8
6 spd
Bronze 5zigen fno1r-c wheels
Like New Nitto 555 tires
Autometer Nexus seris gagues
- boost
- oil pressure
- oil temp
- air/fuel
- egt
- fuel pressure
Axial Flow short shifter
Profec b spec II Boost controller
AEM meth injection
BHR throttle body spacer
Battery relocated to trunk
Newer Optima Yellow Top
Racing beat front swaybar
Racing beat front endlinks
Racing beat rear sway bar
R-Magic replica Front bumper
Magniflow cat-back exhaust
Mazsport dual resonated midpipe

Motor was a Steve Kan rebuild around 3k miles ago and included Esmeril Racing Apex Seals
All new Atkins Seals and bearings.

The turbo kit is using an Esmeril racing manifold and downpipe.
Turblown's Hybrid GT35 journal bearing water cooled turbo
Tial Wastegate
Microtech
All Samco silicone couplers
Stainless t-bolt clamps
Original Esmeril racing BOV
Original Esmeril Racing intercooler

The Bad:
Obviously the crack in the housing
Dent in passanger side door
Normal dents and dings for an 05
Engine under tray has been worn and damaged
Cracked front fiberglass bumper.
NO PRO TUNE FOR BOOST USE.


These are some older pictures that i have online. I will post up some newer ones tonight when i get off work. At the moment the motor is in the process of being torn down for repairs, however, if i dont have to make the repairs i will re assemble it to running condition.







And a video of the leak:

http://s232.photobucket.com/albums/e...IDEO0001-1.mp4

Phish806

iTrader: (4)

I figured i would get a couple low ***** and an ask to part out atleast lol

Dynamito

dibs on bumper if you part out!

Phish806

iTrader: (4)

If i part out the car i would most likley just part out the performance parts and the engine. Would part out the kit, the engine, meth kit, clutch and so forth...

Themare

iTrader: (1)

parting out the magnaflow exhausts? ;D

Phish806

iTrader: (4)

Exhaust stays on the car. Looks like i am parting out the turbo kit and the motor though.