You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join RX8Club.com today!
I have a six port engine and standard tranny for sale in the Texas area if anyone is interested. I'm located in Seguin, TX near San Antonio. I want to try to sell it locally before moving toward shipping it. I bought both used with 16,000 miles on them. Out of a 2005, or 2006 I can't remember. It's a "semi' complete engine, needing a primary fuel rail, injectors, and an accessory crank pulley. No A/C pump, and there might be a few other odds and ends/hardware missing as I tend to lose things a lot. The engine harness is uncut and I have the ecu. I'm looking for $2,300 for both. Or, $1,800 for the engine and $600 for the tranny. I'll hopefully have pics here in the next few days. I'm a newbie here for the most part, but I've sold quite a few things on RX7Club.com with no complaints. You can contact me at warick99@yahoo.com, or PM me.
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on RX8Club.com!
Yes, I meant the short block. I'll get pics up this Tuesday or Wednesday sometime. Right now it's in a car with a bunch of stuff piled up on it. I'm rearranging my garage. Sorry, but I'm in the middle of trying to get three restaurants started up, and trying to find a new house on top of it. I'm also trying to get my FD project finished and running before moving. Not a whole lot of time for pulling a motor and taking pics but I will get them up!
Ok, I went ahead and took a pic of the motor as it is now. I hate to post a pic of the motor not fully put together, but I didn't want this to become a "I smell a con artist" thread. I do have the upper intake, throttle body, alternator, trigger wheel, etc...
Ok, I went ahead and took a pic of the motor as it is now. I hate to post a pic of the motor not fully put together, but I didn't want this to become a "I smell a con artist" thread. I do have the upper intake, throttle body, alternator, trigger wheel, etc...
photo is fine. parting it out would be better for you.... i would not reassemble it...
you have the whole car, or is this a 20b swap in the making? i notice the steering rack is gone.
beers
__________________
Thanks, Mr. moody sardonic expert on so many things. Potentiated 09 Banned
All the stuff???? All I need is rum dude; everything else takes care of itself! Kane 09
Actually the car is a 90 Miata. I completely reworked the subframe to get the thing to fit, installed a TII rear end, and fabbed up a PPF for it all. I was at the point of fabbing engine mounts when I abandoned the project for a while. "For a while" may be permanent now. I wasn't happy with a lot of the work I did anyways. I require perfection. The rack is still there, it's just dropped out of the way. Otherwise it bolts right back in where it should be. I probably will be parting it out starting next week. I'm just hoping that someone local will want the full engine/tranny package and take it off my hands with minimal fuss.
Linear Mode
