dual apexi n1 exhaust??
06-20-2006, 11:41 AM
#1
Registered User
Thread Starter
Join Date: May 2006
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
dual apexi n1 exhaust??
i want to know if it will fit, and what you guys think on this setup, i bought two new apexi n1 mufflers, and im going to have a local shop install ne piping from the header back, and the cat will be eliminated, to get all that new piping and installing the mufflers will be $200, so what do you think?? also will the two mufflers fit? i have the mazda speed kit on!
06-20-2006, 04:50 PM
#2
Registered User
iTrader: (1)
Join Date: Apr 2004
Location: The Valley, CA
Posts: 191
Likes: 0
Received 0 Likes
on
0 Posts
Ummm...aren't those the fart cans that ricers use? Taking the cat out will hurt you ears 
I'm sure they can make it fit--why don't you take some measurments.
I'm sure they can make it fit--why don't you take some measurments.
06-23-2006, 12:12 PM
#13
RX8 HA HA
good luck trying to get them to fit, you might even have to remove the exhaust shrouds, there's not a lot of room down there, you might have to set it up with a crazy angle.
06-23-2006, 09:59 PM
#15
Registered User
Thread Starter
Join Date: May 2006
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by XDEEDUBBX
good luck trying to get them to fit, you might even have to remove the exhaust shrouds, there's not a lot of room down there, you might have to set it up with a crazy angle.
06-25-2006, 08:23 AM
#19
Registered User
Thread Starter
Join Date: May 2006
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SayNoToPistons
just make it straight... the N1 already big enough. dont want more attention to the cannons.
yeah, but with the space down there, and the exhaust holes on the MS bumper, i might have to put it a little bit at an angle
Thread
Thread Starter
Forum
Replies
Last Post
RicerX1
West For Sale/Wanted
5
01-11-2016 05:59 PM
