Notices
RX-8 Discussion General discussion about the RX-8 that doesn't fit in one of the specialty forums.

Check engine light

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 03-28-2006, 04:22 PM
  #1  
Registered User
Thread Starter
 
Whoolio's Avatar
 
Join Date: Mar 2006
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Check engine light

Test drove a 2005 MT RX-8 today. I really enjoyed it and am very close to pulling the trigger. However, I was a bit discouraged to see the Check Engine light when I started the car! The saleslady said that it was a result of the car not having been started in a while.

Clearly, the dealer will take care of it, but that's not much of a confidence builder to have the car taken into the shop before it's left the lot.

Anyone think this should be reason for concern?

BTW - the dealer's internet department is offering $5000 below invoice. Apparently, this is a Mazda incentive until the end of the month.
Old 03-28-2006, 04:32 PM
  #2  
Registered User
 
Red Devil's Avatar
 
Join Date: Jun 2002
Location: Misinformation Director - Evolv Chicago
Posts: 3,086
Likes: 0
Received 0 Likes on 0 Posts
Who knows...we would have to see the error code. But that is disconcerting. If it bothers you so much, then get another one they have instead.
Old 03-28-2006, 04:57 PM
  #3  
Administrator
 
zoom44's Avatar
 
Join Date: Jul 2002
Location: portland oregon
Posts: 21,958
Received 115 Likes on 88 Posts
As part of the normal diagnostics the PCM performs for emissions purposes, The RX-8(and otehr vehicles) perform an Evaporative Systems pressure check everytime you shut the car off. Basically this test is looking for pressure changes that could mean fuel vapor is leaking from the car. If the test fails then the next time the car is started the CEL will light. the most common cause for failing the test is a gas cap that has not been tightened properly. Second would be an actually bad sealing gas cap and third is an actual leak in the lines somewhere in the fuel system.

I would never be bothered by the CEL or concerned about the car. Turn the cap a few clicks. If the cel goes off after a couple more drive cycles then you're golden. If it doesnt then its a different issue and the code should be checked. If it goes away and comes back without refueling in between then its probably a leaky gas cap.
Old 03-29-2006, 08:55 PM
  #4  
Registered User
 
born2drive's Avatar
 
Join Date: Mar 2006
Location: Missouri
Posts: 125
Likes: 0
Received 0 Likes on 0 Posts
I would not be concerned about the CEL being on either. They will fix the problem. You also have an awesome warranty with this car so if it isn't fixed right away it will be eventually. My check engine light came on right after I bought my 8. It turned out to be a bad selenoid. Two hours in the shop and I was back on the road. Mazda is really good with their service. At least from my experience anyways.
Old 03-29-2006, 09:08 PM
  #5  
Registered User
 
Captain Amazing's Avatar
 
Join Date: Apr 2004
Posts: 357
Likes: 0
Received 0 Likes on 0 Posts
I have had a CEL for awhile. Im taking it in tomorrow.
Old 03-29-2006, 09:48 PM
  #6  
Ike
Blue By You
 
Ike's Avatar
 
Join Date: Jun 2003
Location: Milwaukee
Posts: 8,717
Likes: 0
Received 0 Likes on 0 Posts
$5000 below invoice??? Hell, I'll go buy one if that's the case
Old 03-29-2006, 09:55 PM
  #7  
Registered User
 
Animagix's Avatar
 
Join Date: May 2005
Posts: 312
Likes: 0
Received 0 Likes on 0 Posts
mazda people need to get their **** together. seriously. everytime i log onto this forum there's always a flood, warped rotors, CELs, poor MPG or some other ****. Thankfully I have yet to experience a flood or CEL (knock on wood)
Old 03-29-2006, 10:04 PM
  #8  
Registered User
 
dazygirl415's Avatar
 
Join Date: Oct 2004
Posts: 1,090
Likes: 0
Received 0 Likes on 0 Posts
Why does everyone think that Mazda and this car are so horrible just because people have problems with their car? There are problems with EVERY manufacturer and EVERY vehicle. We don't hear about them because we don't frequent websites that talk about them. If you don't want to hear about the problems, then quit visiting the forum and live in your bubble.

AND flooding is the nature of the rotary engine and CELs are used to notify the driver that something may be wrong. Wouldn't you rather be told ahead of time that something may be wrong instead of getting stranded in the middle of no where with a broken car and no clue what to do because you didn't know there was a problem to begin with?
Old 03-30-2006, 08:59 AM
  #9  
Registered User
 
Red Devil's Avatar
 
Join Date: Jun 2002
Location: Misinformation Director - Evolv Chicago
Posts: 3,086
Likes: 0
Received 0 Likes on 0 Posts
^^^
Thank you, very good points.

The reason this forum may at times make Mazda and this car look bad is because rarely do people come on to praise something. No one comes on here and says:
"I just took my RX-8 to XYZ Mazda and they did the oil change and brake pad TSB perfectly. Wow, I just love Mazda."
But when the dealer overfills the oil, or doesn't fix the brake pads issue, then all hell brakes loose and the venting is done on here.
Old 03-30-2006, 09:48 AM
  #10  
I don't buy Kool-Aid
 
DOMINION's Avatar
 
Join Date: Apr 2004
Location: Vegas Baby!
Posts: 8,823
Likes: 0
Received 2 Likes on 2 Posts
Why do people just test drive cars see this kind of stuff that can be easily fixed then stumble across these forums and ask questions on it? I don't get it.
You should do your home work on the car before your purchase. And use the dam search button if your looking for info on your soon to be new purchase and not just decide to purchase a car then find out its not reliable for your needs or its falling a part. I knew the rotor got hot as hell and burned gas and use oil like TP but I made the decision to purchase on many factors not just one.
Old 03-30-2006, 09:56 AM
  #11  
脾臓が痛みました
 
Glyphon's Avatar
 
Join Date: Mar 2005
Location: Land of Peaches, Pecans, and Peanuts
Posts: 1,527
Likes: 0
Received 2 Likes on 2 Posts
Originally Posted by dazygirl415
AND flooding is the nature of the rotary engine
just to clarify...flooding is the nature of internal combustion engines. rotary engines are unique from piston engines only in the fact that they don't have any path for the excess fuel to eventually leak out of the engine through. in piston engines, this is down through the motor and into the oil. flooded a piston engine? let it sit for a while, and then try to crank it. if it starts up, let it run for a few mintues, then change the oil. doesn't start up? let it sit a while longer.

with the rotary engine, the fuel has no place to go, so it will sit there until it is manually flushed out.

and going to a different post, warped rotors is not a problem that i've heard about on this car. i think that person is confusing his cars

and car forums are going to make any car seem worse than it is, because the members are either enthusiasts, or someone that had a problem (at least initially), so any problem is going to be blown out of proportion. its the nature of the beast. accept it for what it is, and understand that is overblown, or just stop reading the forums. it will be like that for any car manufactured out there.

wow...i kind of got on a soap box there. sorry.
Old 03-30-2006, 11:55 AM
  #12  
Rotary Wanker
 
Ericok's Avatar
 
Join Date: Sep 2005
Location: Washington, DC
Posts: 413
Likes: 0
Received 1 Like on 1 Post
[QUOTE=Red Devil]^^^
No one comes on here and says:
"I just took my RX-8 to XYZ Mazda and they did the oil change and brake pad TSB perfectly. Wow, I just love Mazda."
QUOTE]

I just took my RX-8 to Brown's Alexandria Mazda and they did the oil change perfectly. I didn't need the brake pad TSB - or any other TSB for that matter. I have had ZERO problems with this car. Even the mileage is in the EPA ballpark.
Old 03-30-2006, 12:17 PM
  #13  
rotorized!!!
 
daisuke's Avatar
 
Join Date: Feb 2006
Location: San Luis Obispo, CA
Posts: 653
Likes: 0
Received 0 Likes on 0 Posts
look at it this way too, you can buy the car and enjoy and if there are lemon laws where you live you can give it back if they can't fix it. 5000 off of invoice is something you can't pass up.
Old 03-30-2006, 12:20 PM
  #14  
Club Marbles Member
 
Raptor2k's Avatar
 
Join Date: Jul 2005
Location: DFW, TX
Posts: 3,252
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Ike
$5000 below invoice??? Hell, I'll go buy one if that's the case
!!!!!!!!
Old 03-30-2006, 12:23 PM
  #15  
Rotary Wanker
 
Ericok's Avatar
 
Join Date: Sep 2005
Location: Washington, DC
Posts: 413
Likes: 0
Received 1 Like on 1 Post
DARCARS of Silver Spring, Md says $4,000 below invoice or 0% financing (must be pocketing the extra grand).
Old 04-03-2006, 10:17 PM
  #16  
Registered User
Thread Starter
 
Whoolio's Avatar
 
Join Date: Mar 2006
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Sold!

Picked it up this weekend. '05 GT 6MT in Winning Blue. The price was ultimately only (lol) $4000 below invoice. There was an additional $1000 incentive if one financed through Mazda credit. That incentive expired on March 31; I bought on April 1

No worries. I couldn't be happier with the car. Thanks to everyone on the site for all the great posts. I was able to find answers to just about every question I had.

Now I just have to keep reminding myself to keep the RPMs down while breaking in the engine!

If anyone's interested, I'm happy to post the exact dollar amounts.
Old 05-24-2006, 02:19 PM
  #17  
Registered User
 
snkpkp's Avatar
 
Join Date: Jan 2006
Location: Dhaka, Bangladesh
Posts: 158
Likes: 0
Received 0 Likes on 0 Posts
help yourself finding a lot of posts here which gives good directions (better than your dealer will) to do a good breaking in for the car.....
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ladnarf1
New Member Forum
4
04-29-2021 11:53 PM
vapor2
West For Sale/Wanted
11
11-03-2020 03:38 PM
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM
marc2820
New Member Forum
6
07-26-2015 10:47 PM
netrovers
New Member Forum
6
07-20-2015 03:32 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Check engine light



All times are GMT -5. The time now is 10:19 PM.