You are currently viewing our forum as a guest, which gives you limited access
to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join RX8Club.com today!
I just got the LED Interior Light Set (not talking about the footwell or map light sets, even tho i got those too :-P) but they didn't come with any instructions...
Anyone done this installation already and know how to disassemble the door light pod off and where this third fuse looking LED bulb set goes?
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on RX8Club.com!
so i was trying to install the interior leds and the bulb holder got pushed into the door cavity anyone have any ideas how to get it back into place? on the same note, how do you take out those bulbs anyways? theyre so hard to pull out or get a good grip on
I've had this happen. It'll be a bit tricky but what you need to do is pop out the bottom corner of the door (closest to the bulb) Just give it a tug, should pop out.
Then either with some needle nose pliers, try and grab the wires and pull it back up.
yeah, there shoudl be a plastic tab that just comes out. don't pull too hard, you might start loosening other clips that you don't want loose right now.
jedi i'm tugging and tuggin on that black piece closest to the bulb area and no bueno! can you be more specific on what to do....this stupid easy mod is turning out to be a 2 hour job
anyone have any ideas how to get it back into place? on the same note, how do you take out those bulbs anyways? theyre so hard to pull out or get a good grip on
Linear Mode
