Notices

dannobre

Modulated Moderator

About Me

  • About dannobre
    Location
    Smallville

Statistics

Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: Jun 8, 2026 04:04 PM
  • Join Date: Feb 7, 2004

Friends

Showing Friends 1 to 10 of 24

Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. Lightnin
    Jan 23, 2026 05:41 PM - permalink
    Is there a moderators group talk I can talk to? I have not heard back and it looked like you were active last night. Time is of the essence here.
  2. Lightnin
    Jan 22, 2026 07:41 PM - permalink
    Hey Dan, I'm trying to start a thread in the troubleshooting section for S1 (2005 GT) The site is telling me I don't have sufficient rights. I've been a member for years but not active for a long time.
    Anyway, I did not see my issue addressed in the forums and wanted some input. my 15A engine fuse blew while driving and then nothing, no click even on start, . It continues to blow when the key goes to the ON position. There must be a short but where? there are like 5 things on that fuse. I'm guessing the coils are the culprit but I have not found anything obvious. I just moved to a new state and know no mechanics and need to get this fixed. Can you help me get a thread started? I pulled one of the coils and I cannot find any values for what indicates good or bad coils. These coils are not OEM and were replaced by Pettit in Florida 2 years ago.
    Thanks ,
    Lightnin
  3. mrmojo
    Feb 17, 2025 02:08 PM - permalink
    I have seen you reply in several threads about resting the OMP sensor, can't can find any that list the steps. Would you be able to tell me the steps? Any help would be greatly appreciated.
  4. Nick199424
    May 12, 2023 11:18 AM - permalink
    Hello! I am reading a thread about resetting my oil metering pump on a 2004 rx8 that is in limp mode. I run a little mechanic shop but as of now I know close to nothing about rotary's. Are you still offering help if I end up needing it?
  5. 5:00
    Nov 8, 2018 10:40 AM - permalink
    Good morning! I haven't been on the forum for about 4 years. It is not letting me post anything and I have a MOP question about a code that was kicked back. Specifically about the stepper motor circuit that I can't find answers for. Can the account be reset to post?
    Thanks,
    Franck
  6. Mangoose
    Feb 26, 2018 05:25 PM - permalink
    Hi, I am not able to start a thread. I have been a member since 2009 (granted I havent been on the forum in years), but I get the following error:

    Mangoose, you do not have permission to access this page. This could be due to one of several reasons:

    Your user account may not have sufficient privileges to access this page. Are you trying to edit someone else's post, access administrative features or some other privileged system?
    If you are trying to post, the administrator may have disabled your account, or it may be awaiting activation.

    Could you look into this? Thanks!
  7. ANIBALRX8
    Jan 26, 2016 10:58 AM - permalink
    Hey this is Anibal my cell is 253-468-3848, I have tool and am of on thrusday and Friday but it going to rain on does day and I don't have a garage, I have a friend that has a canopy that I can get if you still want to do it, if not we can wait, so just let me know please.

All times are GMT -5. The time now is 01:50 PM.