{WTB} 2004 RX-8 engine
#1
2004 RX-8 engine
Hi there sorry if this is not in the proper area but I live in Vancouver BC Canada.
I have a 2004 RX-8 GT and recently have had an engine breach and now I have white sweet smelling smoke come out the exhaust on start up. After about 5 min or so the white smoke disappears and it runs normally after that.
I have had my engine coolant light come on and now I have noticed under the car is some oil.
Took it to dealership and they said it needs a new motor.
Can anyone suggest where I can get a decent motor. Dealership says $5200 installed for a re manufactured engine from mazda. not sure what to do here.
Any advice would be greatly appreciated.
Thank you
I have a 2004 RX-8 GT and recently have had an engine breach and now I have white sweet smelling smoke come out the exhaust on start up. After about 5 min or so the white smoke disappears and it runs normally after that.
I have had my engine coolant light come on and now I have noticed under the car is some oil.
Took it to dealership and they said it needs a new motor.
Can anyone suggest where I can get a decent motor. Dealership says $5200 installed for a re manufactured engine from mazda. not sure what to do here.
Any advice would be greatly appreciated.
Thank you
#3
Registered
Hey, Im located in Kelowna, BC. Just a few hours from Vancouver. My motor just seized aswell. Here is the thread.
https://www.rx8club.com/new-member-f...5/#post4811491
But could you let me know a better place to get a motor aswell? Than mazda They're saying 5200$ here aswell.
https://www.rx8club.com/new-member-f...5/#post4811491
But could you let me know a better place to get a motor aswell? Than mazda They're saying 5200$ here aswell.
#4
Hae Mazda rebuit engine for sale with 22k on it
I am converting a 2004 RX8 to electric, and have pulled out a Freeway Mazda rebuilt engine with 22k on it. Asking $2000. Have all receipts and can show a video of car running.
Regards,
Gary
6046144150
Regards,
Gary
6046144150
#6
Registered
$5200 installed is high but not that pricey tho. Anyway, try contacting ForceFed or Rotary Steve for a rebuild quotation, since they might have a better deal. They will have to pull apart your motor for an exact quote.
@OP your coolant seal probably is a goner and rebuild motor like that could be pricey.
P.S. If I remember correctly Gary motor was rebuilt by Rotary Steve and he might have a compression number right before he took it out of the car.
**EDIT** my mistake just saw his post it was rebuilt by Freeway Mazda
@OP your coolant seal probably is a goner and rebuild motor like that could be pricey.
P.S. If I remember correctly Gary motor was rebuilt by Rotary Steve and he might have a compression number right before he took it out of the car.
**EDIT** my mistake just saw his post it was rebuilt by Freeway Mazda
Last edited by vwrecca; 05-29-2017 at 12:40 AM. Reason: mistake
#7
Registered
$5200 installed isn't that bad at all. But the Mazda remans have been a little questionable in the past. Even if it were $4000 I'd probably opt to spend more and go with a reputable builder rather than roll the dice again with Mazda.
Thread
Thread Starter
Forum
Replies
Last Post
BAK
Series I Trouble Shooting
4
09-13-2014 11:40 AM
wangel
New Member Forum
15
08-05-2013 09:17 AM