Hi guys,

I've recently installed the MS style CF wing. The piece where its bolt on to the trunk lid doesn't stick well. Basically when i bolt the two ends to the stand, the centre pops-up, the 3M tape doesn't have the strength enough to hold it in place, thus now, there's a hold in middle between the lower lip and the trunk lid.

My question is, can Carbon Fiber be bended? Wanna know this before I take the wing apart again. I thought of elevating the both end of the lower wing and apply pressure to the middle and probably leaving it for a day or 2. Do you guys think this method would help me to bend the wing back in shape?

Appreciate any comments or suggestions.

Cheers