Replaced tranny, car wont go into gear when on!
Thread Starter
FLAME ON!
Joined: Jul 2009
Posts: 948
Likes: 0
From: Strip Club
Replaced tranny, car wont go into gear when on!
Car won't go into gear when the car is on. I have a brand new clutch and fly wheel and a replacement trans that only had 12k on it. Questions, ideas or help? 
reinstall? maybe something got messed up in the process....
EDIT:
Maybe there is an issue with the slave cylinder not sending properly..that would prevent the car from going into gear. My little brothers 72 midget had this problem
EDIT:
Maybe there is an issue with the slave cylinder not sending properly..that would prevent the car from going into gear. My little brothers 72 midget had this problem
Registered
Joined: Nov 2009
Posts: 596
Likes: 0
From: Adriatic Paradise
a) Clutch plate maybe installed backwards and fouling flywheel
b) Throwout bearing not located correctly on clutch fork
c) Bleed clutch hydraulic system
d) Possibility of mix matched clutch plate and pressure plate
Maybe ????
b) Throwout bearing not located correctly on clutch fork
c) Bleed clutch hydraulic system
d) Possibility of mix matched clutch plate and pressure plate
Maybe ????
Thread Starter
FLAME ON!
Joined: Jul 2009
Posts: 948
Likes: 0
From: Strip Club
Courtesy (Dealer ship) gave me a shitty clutch, we installed a new one. I got one pretty cheap and we MIGHT be able to return the one I got from Courtesy as defective so I MIGHT get that cash back.
I am writing a letter to Mazda corporate today complaining about them and that there is no where in NV that I can take my car that I can trust.
At least my car is back though right?
I am writing a letter to Mazda corporate today complaining about them and that there is no where in NV that I can take my car that I can trust.
At least my car is back though right?
Thread
Thread Starter
Forum
Replies
Last Post
Dokuji
Series I Trouble Shooting
8
Nov 1, 2016 02:51 PM
BigMikeATL
RX-8's For Sale/Wanted
12
May 26, 2016 12:31 AM
