Just a quick question has anyone ever removed one of the screens on the mazda cold air intake system and if so did they have any problems?

the screens smooth out the airflow, right? Thus your Mass air flow sensor doesn't freak out...

I would keep the screens in...

^+1... plus I hear that removing a screen doesn't really gain much (not like the intake gains much anyway).

i just ordered my Mazdaspeed CAI, just waiting for it to come in.

waiting



waiting


waiting.

i just ordered my Mazdaspeed CAI, just waiting for it to come in.

waiting



waiting


waiting.

dude, your avatar is freaking me the fuck out. lol

dude, your avatar is freaking me the fuck out. lol

hahahaha. ive been having this avatar for close to 5 years on various forums i post on, and im still getting PMs for me to change it. in fact on the RX7club. there was once a thread about me changing it :lol2:

quick question. if one of the pipes from the ms cai get bent at the opening will it effect its performance?

if you remove the screens the car wont run right.. itll kinds feel like you have a mis fire CEL comes on as well.. I removed my intake and when i re installed i left one of those screens unproperly places and the car was freaking out!

Leave them in.. You have 2 screens

quick question. if one of the pipes from the ms cai get bent at the opening will it effect its performance?

it shouldnt but if its bent tothe point where it looks oval i wouldnt know abotut hat but if its just a little tiny bend it shouldnt affect.. my was alittle bent but nothing your wouldnt notice unless you are a good observer

hahahaha. ive been having this avatar for close to 5 years on various forums i post on, and im still getting PMs for me to change it. in fact on the RX7club. there was once a thread about me changing it :lol2:

it sure is creepy lol

something about clowns that scares people haha always reminds me of that movie IT

especially that part int he gutter used to get me all the damn time when i was a kid:banghead:

I only put the screen closest to the maf in when I installed my MS CAI. Runs fine, idle fluctuates on occasion, but I never tried it with both so I don't know if that CAI makes it do that anyway.

what about the filter sock? is that to be used just to keep the filter clean when you are installing it? or are you suppose to leave it on?

what about the filter sock? is that to be used just to keep the filter clean when you are installing it? or are you suppose to leave it on?

Leave it on... this will help repel dirt and other stuff while driving.
It will also help with SMALL droplets of water... but don't think that you can spray a garden hose at it (like when you're cleaning your car). Your filter will collect the water and after time, the water thats collected will get so bad, when you turn and accelerate quickly, the water will rush up your intake pipe and into the engine (NOT GOOD).
I speak from personal experience. Thats why I just switched out my AEM for the Racing Beat Revi with the ram air duct.

Ok intake wise, im looking to upgrade. Racing Beat has a good intake so I hear, any suggestions would be cool.

Ok intake wise, im looking to upgrade. Racing Beat has a good intake so I hear, any suggestions would be cool.

Racing Beat is a good intake... especially with the ram air duct addition.
Only "issue" I have with the Racing beat (which I didn't know until I went to install it) is that it requires the use of stock components from the air box (like the grommets, hose clamps, bolt, spacer, and the accordion section).
I installed the AEM intake YEARS ago and couldn't find some of the stock pieces that was thrown in the closet, so that made the install take more than it should... trying to scrounge up everything.