View Full Version : 3m bumper covering


Cwsmith
10-15-2003, 08:16 PM
I took a good look in the Canada forum but I could not seem to locate a dealer that installs this type of accesory.

I am looking for one in the Kinsgton-Ottawa-Cornwall area. And if you know, what did you pay? Looking for the whole front bumper, hood, and mirrors.

Wing
10-15-2003, 08:35 PM
Wow an RX8 in Cardinal? You must be the talk of the town ;)

There is one in Ottawa for sure, mac might chime in although he might not check the forum as much since he decided not to buy till spring.

Cwsmith
10-15-2003, 09:10 PM
Possible phone number? address? Name?

The help is much appreciated.

Gord96BRG
10-15-2003, 09:50 PM
Go to www.xpel.com , and click the "find an installer" button. I had the XPEL 3M kit installed on my RX-8 in July, and am very happy with it. I posted the costs somewhere in here back then - somewhere around $500, if I recall correctly (do a search here to find it!)

Regards,
Gordon

Cwsmith
10-15-2003, 10:00 PM
About 420Km to the closest US dealer. NO listed dealers in Canada. Odd but thats what it says.

Gord96BRG
10-15-2003, 11:45 PM
I'm not sure what you're entering for a postal code - for example, check out 'T2P 3P7' (a downtown Calgary postal code) - it will list 5 XPEL agents in Calgary (I used the 5 star guy :D)!

Edit - just for fun, I went to the Mazda.ca web site to find a postal code for Ontario - I grabbed M5A 3T7 for Downtown Mazda in Toronto, and it lists 8 XPEL dealers in the area.

Regards,
Gordon

Cwsmith
10-16-2003, 06:27 AM
I don't know where the cutoff for "local" is on the site, but Ottawa-Cornwall are about 1hr. away TO is ~4hrs. So TO must just be to far away from my Pcode to list, and thats why I got the US install site.


Note: I also entered Kingston Mazdas Pcode into the xpel web site and they are only <3hrs to TO, but still got US install sites.

Wing
10-16-2003, 07:09 AM
Try PMing mac.

mac
10-16-2003, 07:44 PM
Hey Cwsmith, check your PM :) I don't post much these days since as Wing mentioned I've decided to wait until spring. I still lurk once or twice a week. There is a local shop "Car-on" on Cyrville (417 and Innes) who has a sub-contractor who does 3M products however as I mentioned in an older thread he does not use pre cut forms. I am trying to convince him otherwise :D . I'll give him a call tomorrow to see if things has changed now that the car has been out for a bit. I'll let you know as well as pricing.