Anyone try to install the MS front spoiler with theheadlight washer? Chuck from rotaryextreme said need to cut it on my own???

Will that fit? Is there ways to adjust the washer to make it work coz I think the front spoiler will block the line of the washer.

I rather not have the washer... what do you think?

I dont have the washers
but I'd lose them if I got the ms kit

Really mikeb? Why?

It is kinda compulsory for Xenon light to have washer from the dealer but I dont think it is an offense to take them out

I say that because I have never used a headlight washer in my life and I dont think it is all that necessary.
yes it is nice but not really necessary

i think they wouldn't be that hard to install in the MS front all you would have 2 do is drill a hole but i'm not sure as i haven't seen the MS kit in person but it surely can be done.

I'd try 2 keep them if i was you as they are very kool but if it comes down to the MS front or the Headlight washers go 4 the MS front IMO

For the amount you use the headlight washers I would lose them rather than chance a messed up MS front end. We are talking about the whole nose here and not just a lower spoiler. Also, if you spending the money for and MS Appearance Kit you probably detail your car regularly and thus rarely if ever would have the need for the headlight washer. By the way, they are not even available or an ooption on the US RX-8.

neither it is available via Mazda Australia. I think I have to import them. Importing the side and rear factory reflectors too - much cheaper PAINTED.

Tori